Panasonic of North America 96NKX TGA950 User Manual

Installation Manual
Model No. KX-TGA950
Additional Digital Cordless Handset
Thank you for purchasing a Panasonic product.
This unit is an additional handset compatible with the following series of Panasonic Digital Cordless Phone: KX-TG9541 (The corresponding models are subject to change without notice.) You must register this handset with your base unit before it can be used. This installation manual describes only the steps needed to register and begin using the handset. Please read the base unit’s operating instructions for further details.
Please read this installation manual before using the unit and save it for future reference. For assistance, visit our Web site: http://www.panasonic.com/help for customers in the U.S.A. or Puerto Rico.
One Panasonic Way, Secaucus, New Jersey 07094
© Panasonic System Networks Co., Ltd. 2013
Printed in China
PNQX6077ZA
TT0613MU0 (E)
TGA950(en)_0325_ver001.pdf 1 2013/03/25 12:51:19

Accessory information

Supplied accessories
Accessory item/Order number Quantity
Charger/PNLC1040ZB 1
Rechargeable batteries/HHR-4DPA 2
Handset cover*1/PNYNTGA950BR
1
Belt clip/PNKE1268Z1 1
*1 The handset cover comes attached to the handset.
Note:
R Please read the base unit’s operating instructions for additional/replacement
accessories. – Optional headsets: KX-TCA60, KX-TCA93, KX-TCA400, KX-TCA430

Setting up

Connections/Wall mounting
27.2 mm
(1 / inches)
Screws
(Not supplied)
To power outlet
1
16
Note:
R The AC adaptor must remain connected at all times. (It is normal for the adaptor
to feel warm during use.)
R Make sure that the wall and the fixing method are strong enough to support the
weight of the unit.
2
For assistance, please visit http://www.panasonic.com/help

Installation

TGA950(en)_0325_ver001.pdf 2 2013/03/25 12:51:20
Battery installation/Battery charging
Important:
R Use the supplied rechargeable batteries. For replacement, we recommend using
the Panasonic rechargeable batteries noted on page 2.
R Wipe the battery ends (
, ) with a dry cloth.
R Avoid touching the battery ends (
, ) or the unit contacts.
R Confirm correct polarities (
, ).
R USE ONLY Ni-MH batteries AAA (R03) size. R Do NOT use Alkaline/Manganese/Ni-Cd batteries.
Charge for about 7 hours. R When the batteries are fully charged, “Fully charged” is displayed.
Rechargeable Ni-MH ONLY
Confirm
Charging
is displayed.
Note:
R If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends (
, ) and the charge contacts with a dry cloth and
charge again.
Registering a handset to a base unit 1 Base unit:
Press and hold MLOCATORN for about 5 seconds. R Depending on the base unit, a registration tone sounds. R If all registered handsets start ringing, press MLOCATORN again to stop,
then repeat this step.
2 Handset:
Place the handset on the base unit or charger, then wait until a long beep sounds and
is displayed.
Note:
R If an error tone sounds, or if
is displayed, register the handset according to
the base unit’s operating instructions.
For assistance, please visit http://www.panasonic.com/help
3
Installation
TGA950(en)_0325_ver001.pdf 3 2013/03/25 12:51:20
Display language 1 MMENUN#110
2 MbN: Select the desired setting. a MSAVEN a MOFFN

For your safety

To prevent severe injury and loss of life/property, read this section carefully before using the product to ensure proper and safe operation of your product.
WARNING
Power connection
R Completely insert the AC adaptor/power plug into the power outlet. Failure to do
so may cause electric shock and/or excessive heat resulting in a fire.
R Regularly remove any dust, etc. from the AC adaptor/power plug by pulling it
from the power outlet, then wiping with a dry cloth. Accumulated dust may cause an insulation defect from moisture, etc. resulting in a fire.
R Unplug the product from power outlets if it emits smoke, an abnormal smell, or
makes an unusual noise. These conditions can cause fire or electric shock. Confirm that smoke has stopped emitting and contact the Panasonic Call Center at 1-800-211- PANA (1-800-211-7262).
Installation
R To prevent the risk of fire or electrical shock, do not expose the product to rain
or any type of moisture.
R Do not place or use this product near automatically controlled devices such as
automatic doors and fire alarms. Radio waves emitted from this product may cause such devices to malfunction resulting in an accident.
CAUTION
Installation and location
R The AC adaptor is used as the main disconnect device. Ensure that the AC
outlet is installed near the product and is easily accessible.
Battery
R We recommend using the supplied batteries or additional/replacement batteries
noted on page 2 for replacement battery information. USE ONLY rechargeable Ni-MH batteries AAA (R03) size.
R Do not mix old and new batteries.
4
For assistance, please visit http://www.panasonic.com/help
Installation
TGA950(en)_0325_ver001.pdf 4 2013/03/25 12:51:20
Loading...
+ 7 hidden pages