Panasonic WZ-DE45NH User Manual

DIGITAL SIGNAL PROCESSORS

Model No. WZ-DE45NH
Input No. of Channels 2 ch

Analog
Type Electronic balance
Rated Input +4 dB
Maximum Input +24 dB or more
Connector XLR-3-31 or equivalent, x2
Input Impedance 20 kΩ
In-Phase Reject Ratio 40 dB or more
A/D Converter 24-bit ∆-∑ type
Digital
Type AES/EBU format, for professional use
Sampling Frequency 48 kHz±0.1%
Connector XLR-3-31 or equivalent, 1 connector

Output No. of Channels 2 ch

Analog
Type Electronic balance
Rated Output +4 dB±1 dB
Maximum Output +24 dB or more (at 10 kΩ load)
Output Impedance 150Ω
Connector XLR-3-32 or equivalent, 4 connectors
Applicable Load Impedance

600Ω or more

D/A Converter 24-bit ∆-∑type
Digital
Type AES/EBU format, for professional use
Sampling Frequency 48 kHz
Connector XLR-3-31 or equivalent, 1 connector

(Recommended cable: Canare Electric DA206 or equivalent)

Pattern Type

Make contact type, No. of control patterns: 12 + MUTE, BYPASS

Control Anti-reverse diode provided

Connector D-SUB 15-pin, setscrew M2.6

Recommended connectors

Male: OMRON XM2A-1501 or equivalent
Hood: OMRON XM2S-1511 or equivalent

Power Supply

AC220V~~AC240V 50/60 Hz

Power Consumption

16 W (as defined in the Electrical Appliances Control Act)

Heat Flow 16 W (12 kcal)

* The figure in parentheses is calorific value per hour.

Stacking Conditions 2 units high maximum

* If you are using 3 units or more, leave a space for a unit or more every 2 units.

Dimensions 480 (W) x 44 (H) x 280 (D) mm (without rubber feet)
Weight (approx.) 4.5 kg

Note: "RAMSA-NET" is a protocol exclusive to Matsushita Communication Industrial Co., Ltd.,
used to send and receive data between the host computer and two or more audio control units
connected to it with communication lines.

General Frequency Response 20 to 20,000 Hz, +0.5, –1.0 dB

Dynamic Range Analog input/output (typ, IHF-A)

115 dB (noise gate ON)
109 dB (noise gate OFF)

THD

0.015% at +4 dB, 20 to 20,000 Hz, 30 kHz LPF (at 600Ω load)

Crosstalk –70 dB or less (10 kHz)
User Memory 16 memories + 1 simple memory
External Type RS-485 RAMSA-NET (See Note.)
Control Connector D-SUB 9-pin, IN/OUT 1 each, setscrew M2.6

Recommended connectors

Male: OMRON XM2A-0901 or equivalent
Female: OMRON XM2D-0901 or equivalent
Hood: OMRON XM2S-0911 or equivalent

Unit : mm

44

32

480
465

275

5

Digital Multi Equalizer

WZ-DE45NH

•

2 inputs and 2 outputs.

•

6 functions: Graphic equalizer function, parametric

equalizer function, delay function, notch filter function,

compressor/limiter function and noise gate function.

•

Built-in a digital audio interface and conforms to the
AES/EBU format.

•

24-bit A/D and D/A converters are employed for analog
inputs and outputs to offer a dynamic range close to that
of an analog device.

•

The notch filter can be automatically set to match the
sound field.

•

All settings can be saved in up to 16 patterns in the

memory.

SPECIFICATIONS

Dimensions

GEQ PEQ NOTCH GATE COMP BLOCK

Rear Panel

PUBLIC ADDRESS RAMSA