Panasonic WV-CR1S Installation Guide
Operating Instructions
Included Installation Instructions
Dome Cover
Model No.
Before attempting to connect or install this product,
please read these instructions carefully and save this manual for future use.
The model number is abbreviated in some descriptions in this manual.
WV-CR1S
Precautions
Refer installation work to the dealer.
Installation work requires technique and experience. Failure to observe this may cause fire, electric
shock, injury, or damage to the product.
Be sure to consult the dealer.
Mounting procedures
Read the following descriptions together with the Installation Guide of the camera. The WV-SFR631L
is used as an example in these descriptions.
Note:
● When a smoke type dome cover is used, the IR LED irradiation distance and the illuminance level
for switching between color and monochrome are lower than for a standard clear type dome
cover. Check the settings after attaching the enclosure.
Step1
Remove the enclosure
from camera
Use the bit included with the camera to loosen
the 2 screws that secure the enclosure, and then
remove the enclosure from the camera body.
Note:
● The enclosure is still connected to the cam-
era with the auxiliary wire at this stage.
Enclosure
fixing screws
(x2)
Enclosure
Camera body
Step2
Remove the auxiliary wire and dome cover
1 Remove the fixing screw* (1 pc., with washer)
that secures the auxiliary wire to the enclosure.
2 Remove the 2 fixing screws
* (2 pcs., without
washers) that secure the dome cover anchor
bracket to the enclosure.
3 Remove the dome cover anchor bracket, light-
blocking sheet, and the dome cover. (Do not
remove the dome sheet.)
These 3 fixing screws, the dome cover anchor
bracket, and light-blocking sheet will be used
again in step 3.
* Depending on the camera used, all 3 fixing
screws may be of the same type (without washers). In this case, please use the removed
screws.
Dome cover anchor bracket
Step3
Replace the dome cover
1 Remove the cover film from the outside of the
dome cover (WV-CR1S). Keep the removed cover
film for future use. (Take care not to damage the
outside or inside of the dome cover.)
2 Attach the dome cover (WV-CR1S) to the enclo-
sure. When attaching, align the 3 holes of the
dome cover anchor bracket and 3 notches on the
lightblocking sheet and dome cover with the 3
protrusions on the enclosure.
3 Using the 2 fixing screws (without washers) that
were removed in step 2, secure the dome cover
to the enclosure.
(Recommended tightening torque: 0.78 N·m
{0.58 lbf·ft})
4 Attach the cover film removed in 1 to the sur-
face of the dome cover.
Auxiliary wire
Dome cover
anchor bracket
Light-blocking
sheet
Dome cover
Dome sheet
Enclosure
Fixing screw
(with washer)
Fixing screws
(without washers)
Protrusions on the enclosure
Loading...