Panasonic WV-CPR650, WV-CPR654 User Manual

Specifications and Main Features

Model: WV-CPR650/WV-CPR654
Pick-up Device: CCD Interline Transfer of 1/3 inch
Scanning Area dimensions: 4.8mm (H) x 3.6mm (V)
Scanning: 30 frames of 528 lines and 60 fields each
Horizontal Resonance: 15.734kHz
Vertical Resonance: 59.94Hz
Synchronization: Internal Line-Locked or VS/VBS or VD2 modules with multiplexer selectable
Video Output: 1.0Vp-p NTSC Composite Video Output of BNC connector of 75 ohm using coax cable
Horizontal Resolution: Line resolution of 480
Signal to Noise Ratio: 50 dB [AGC OFF Weighted ON]
Dynamic Range: It measures 40dB
Minimum Illumination level: Measured at F0.75 Minimum is measured at 0.9 lux (0.09 fc) and at F1.4 it is 3 lux (0.3 fc).
Gain Control: AGC ON or OFF is selectable (MENU SET UP).
White Balance: ATW or AWC is selectable (MENU SET UP).
Electronic Light Control: controllable (MENU SETUP).
Super D Technology: ON or OFF selectable (MENU SETUP).
Electronic Shutter Speed: 1/60 OFF, 1/100, 1/250, 1/500, 1/1000, 1/2000, 1/4000, 1/10000 sec ranges that are selectable.
Lens Mount: C-mount or CS-mount selectable
ALC Lens: Video or DC lens of choice
Ambient Operating Temperature: Range of -10 deg C to +50 deg C which translates to 14 deg F to 122 deg F
Ambient Operating Humidity: Below Ninety Percent
Power Source: WV-CPR650 Utilizes 120 Volt AC adapter at a frequency voltage of 60 Hz and consumes 6.2 Watts of electricity.
WV-CPR654: Poweraution Rating: 60HZ, 6.3W, Voltage: 12V DC 690mA or 24 AC power supply.
Product Measurement ( Excluding lens dimensions) - 2-5/8 W X 2-3/16 H X 4-13/16 D in mm, it is 167/55/23 in weight.
Lens included weight:28oz/ 0.43kg, without lens weight: 0.9 pounds.

Frequently Asked Questions

Q1: What illuminations requirements have to be met while using the WV-CPR650?

A1: For the WV-CPR650 the F1,.4 lens needs to have lux above 3 and with the F0.75 Panasonic lenses the value gets reduced to 0.9 lux.

Q2: What external Power Supply Options are there for the WV -CPR650 P/Camera?

A2: For the camera to work under optimal conditions the user must connect it to a 12V DC (10.5V-16V) or 24V AC power source only.

Q3: Does the mic equipped provide CS Mount/WV cooperating lenses options for the camera?

A3: Yes the mic equipped is compatible with C mount CS lentils.

Q4: (1) If the camera stops working why is it not advisable to open it up? :

A4: The guide explains that opening up the camera does not make sense because it is a user set up which does lack internal user serviced components.

Q5: What types of Pan/Tilt/Zoom Synchronization Modes Does CP-650 Support:

A5: The device provides optional supports to VTR Vertical Lock Switching; Internal, Line Locking and External modes of Synchronization.

Q6: Is it possible to use the camera outside?

A6: Although this camera is intended for indoor use, it can work in certain humidity levels and temperature ranges! However, this camera should not be brought out in the rain or any moist environment.

Q7: Is there an option available to adjust the white balance?

A7: Yes! You can change this by going to the settings and switching between Auto Tracing White Balance (ATW) or Automatic White Balance Control (AWC).