Panasonic WU-SX01A User Manual
Panasonic.
Instructbns
Mono Input Module
WU-SX01A
RAM&l
Bc^O'O (»nemphfia lo confect or operate ih«i product
picàio itiusc lestiuciions carefully
PREFACE
RAMSA's McRO Inpul Module WU-SXOiA ts designed lo use w-ih the Audo Mixer WR-3X1A (W4-SX1) senes
BEFORE INSTALLATION
Be sure 10 set the address or mteinai switch appropnaiely oeiore nry^jr^iing this modiJe mo the Аиою Mixer WR-SXIA (WH-
SXl) series
Oiherwise tne comooter control can not work correetty
REFER TO THE OPERATING INSTRUCTIONS OF AUDIO MIXER WR-SX1A (WRSX1) SERIES FOR THE DETAIL.
SPECIFICATIONS
Dimensions (WJ x 270 (H) x 930 (0) mm
[1 1/4" (W) X 10-6/8" (H) X 36-5/8" {D)|
Weight 1.7ki^(3.7lbs.)
Weight and dimensdns indicated are aoproximate.
Specifications are subject to ciiange without notice.
The senai number of this product may be found on the
top of the unit.
You should r>ote the señal number ot this unit in the
space provided and retain this book as a permanent
record of your purchase to aid identification in the event
of theft.
Model No.
Seri^ No.
WU-SXOIA
WARNING:
TO PREVENT FIRE OR ELECTRIC SHOCK HAZARD. DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
To Users of the WR-SX1 Series
This module is for the WR-SXIA series. If you are a WR-SX1 series user, be sure to read the following instructions
before installing the module.
• If you do not know which series, SX1 or SX1 A, you are using, it is shown on the front cover of the operating instruc
tions or on the nameplate on the rear panel of the device. It can also be checked by model number.
SX1 series: Model WR-SX1/“ (** indicates the number of channels)
SX1A series: Model WR-SX1 A/** {** indicates the number of channels)
[LEVEL MATCH LED colors have been changed.]
• Starting with the SX1A series, the LEVEL MATCH LED lights in two colors.
It lights green, as on the preceding models, when the fader position matches the fader value saved in the memory,
but ft lights red when the fader position exceeds the memory value.
• The LEVEL MATCH LED can be modified to light in green only as on the preceding models if you wish to match it
with the functions of the other modules installed in the device. The method of its modification is as follows:
[Method]
• Remove the R102 shown below by disconnecting it or cutting the lead at the root.
T7
--------------
ST
Panasonic
Broadcast & Television Systems Company
Division of Matsushita Electric Corporation of America
RAMSA/Professional Audio Systems
3330 Cahuenga Blvd. W«l, Los Angeles. CA 90068 1-800-777-1146
PANASONIC CANADA INC.
5770 Ambler Drive, Mississauga, Ontario, L4W 2T3 Canada (905) 624-5010
NM0699-0 YWA8QA5207AN
Printed in USA
Loading...