Stereo Zoom Microphone
VW-VMH3 E/PP
VQT0E01-1
[A]
1.
2.
AB
3.
[B]
b
A
a
c
d
B
a
c
d
C
AA
B
ENGLISH DEUTSCH FRANÇAIS
For storage, avoid places that are very hot (over approx.
∫ Standard Accessories
≥Wind shield (3CX001166)
≥Carrying case (RFC0074-H)
[A] Attaching the Microphone
1. Loosen the shoe lock ring.
2. As shown in figure A, align the foot of the
microphone with the shape of the smart accessory
shoe and slide it into position firmly as far as it will go.
≥
Sliding the foot of the microphone into position while one of
its sides is not properly engaged with the smart accessory
B
shoe as shown in figure
3. Tighten the shoe lock to hold the microphone
securely.
≥Be sure to turn the camcorder (movie camera) off
before attaching and connecting the microphone.
≥When the microphone is attached to the camcorder
(movie camera), never use the microphone as a handle.
≥The power for the microphone is supplied from the
camcorder’s (movie camera’s) accessory shoe (together
with the zoom information).
≥Under extremely windy conditions when the wind shield is
not enough to reduce the wind noise, set [H.SHOE MIC] to
[LOWCUT] in the camcorder’s (movie camera’s) menu to
eliminate wind noise more effectively. (Normally, set
[H.SHOE MIC] to [NORMAL].)
will damage the shoe.
[B] Switching the Microphone [ZOOM/TELE/
WIDE] Mode Selector
ZOOM: In this setting, the direction angle and sensitivity of
the sound pick-up changes according to the
operation of the camcorder’s (movie camera’s)
power zoom function, ranging from stereo sound
recording over a wide area to super-directional
(monaural) recording of sound coming from a
narrow angle from the front only.
≥When you push the zoom lever on the camcorder
(movie camera) toward “W”, the zoom
magnification of the picture is lowered; accordingly,
the stereo effect of the sound being recorded is
gradually enhanced and the sound is picked up
over a wider area.
≥When you push the zoom lever toward “T”, the
zoom magnification of the picture is increased;
accordingly, the angle from which the sound is
being recorded is gradually decreased until the
recorded sound is monaural.
TELE: Only the sound coming from a narrow angle from
the front is picked up and recorded in mono.
WIDE: The sound from a wide angle is picked up and
recorded in stereo.
≥Changing the setting of the microphone [ZOOM/TELE/
WIDE] mode selector during recording is possible, however,
some switching noise may be recorded. It is recommended
to switch in the recording pause mode.
∫ Cautions for Use
≥Do not subject the microphone to strong vibration or shock.
≥Do not use it in the rain or in dusty places.
≥To remove dirt and stains, wipe it with a soft, dry cloth. Do
not use benzine, thinner, alcohol or other chemicals for
cleaning, because they could change the colour and
damage the surface of the microphone body.
≥Be careful that insecticide spray or volatile solvents do not
come into contact with the microphone.
≥
x
C) or very humid (more than approx. 80%). In particular,
60
do not keep it in a closed car in the summer or near a heater.
≥For storage, loosen the shoe lock ring.
≥Do not attach and remove the microphone when the
camcorder (movie camera) is on. This could cause noise in
the picture and sound, or could activate the camcorder’s
(movie camera’s) zoom function.
≥If you record sounds near radio transmitters or high-voltage
lines with this microphone, recorded sounds may be
affected. Avoid such as environment if possible.
∫ Specifications
Information for your safety
Power Source: (supplied by the camcorder (movie
Power Consumption: Less than 25 mA
Microphone Type: Electret condenser zoom
Directional Characteristics:
Frequency Response:100 Hz-13,000 Hz
Sensitivity: Wide; approx. s19 dB
Output Impedanse: Less than 10 ohm
Intrinsic Noise: approx. s77 dBV (Weighting A)
Selectors: ZOOM/TELE/WIDE
Dimensions:
Weight: approx. 70 g
Operating Temperature:
Operating Humidety: 35% - 80%
camera))
DC 7.9 V
(when using AC adaptor)
DC 7.2 V (when using battery)
microphone
(Primary pressure-gradient type
stereo microphone)
(Secondary plessure-gradient type
monaural microphone)
Unidirectional (stereo) Super-directional (monaural)
(in the wide mode)
100 Hz-8,000 Hz (in the tele mode)
(0 dBu1 V/Pa, 1 kHz)
Tele; approx. s15 dB
(0 dBu1 V/Pa, 1 kHz)
Zoom (in the tele mode);
approx. s15 dB
(0 dBu1 V/Pa, 1 kHz)
140 mm (W) k 58 mm (H) k 32 mm (D)
0xC - 40xC
∫ Frequency Response
A In wide-angle view
B In telescopic view
C Directivity pattern (zoom in)
a Relative response
b L (R) sound
c When [H.SHOE MIC] is [LOWCUT]
d Frequency
................................................................................................
Caution
This microphone may experience radio interference caused
by GSM Mobile telephones in calling mode. If significant
interference occurs, please increase the distance between
the GSM Mobile telephone and this microphone.
................................................................................................