Dear Panasonic Customer,
Welcome to the Panasonic family of customers. We hope that you have many years of enjoyment from your new colour television.
The best way to understand the features of this television is to read this book thoroughly, before operating the set.
This television has a low power consumption making it very cost effective to run.
To this end, the standby power consumption is merely 1 watt.
CONTENTS
DWarnings and Precautions3...................
DGeneral Information3.........................
DAccessories4................................
DFitting Remote Control Batteries4..............
DInstallation and Set---up5......................
DLocation of Controls7.........................
DMenu Operation8............................
DTeletext Operation10..........................
DAudio / Video Connections11...................
DVCR Operation12.............................
DTrouble---shooting13..........................
DScart Terminal Information13...................
DSpecifications14.............................
2
WARNINGS AND PRECAUTIONS
DThis T.V. is designed to operate on A.C. 220 --- 240V,50Hz.
DDo not expose this TV set to rain or excessive moisture.
DWARNING: HIGH VOLTAGE !
Do not remove the rear cover, there are no user
serviceable parts inside.
DAvoid exposing the TV set to direct sunlight or other
sources of heat.
DRemove the mains plug from the wall socket when the TV
set is not to be used for a prolonged period of time. Do not
pull the power cable to remove the mains plug from the
socket, always remove it by the plug.
GENERAL INFORMATION
DCABINET AND PICTURE TUBE CARE
Remove the mains plug from the wall socket. The cabinet
and picture tube can be cleaned with a soft cloth
moistened with mild detergent and water. Do not use
solutions containing benzol or petroleum. TV sets can
produce static electricity, care must be taken whenever
touching the TV screen.
DAdequate ventilation is essential to prevent failure of
electrical components. We recommend that a gap of at
least 5cm is left all around this TV even when it is placed
inside a cabinet or between shelves.
Sleep Feature
If the set is not switched off when the TV station stops transmitting , it will automatically go to standby mode after 30 minutes. This
function will not operate when in AV mode.
Last Position Memory
Certain functions have a last position memory, i.e. the setting at the time of switch off will be the setting used when the receiver is
switched on again:
Programme positionColourVolume
ContrastBrightnessStandby
S h a r p ne s sS t a t u sC --- A --- T --- S
3
ACCESSORIES
Check that you have the accessories and items shown
Operating Instruction
book
Te lescopic Antenna
(TX---14JT1C/V)
TSA---120026
Remote Control Transmitter.
FITTING REMOTE CONTROL BATTERIES
Remote Control Transmitter
EUR511300
Batteries for the
(2 x R6 (UM3) size)
1
D Make sure that the batteries are fitted the correct way round.
D Do not mix old batteries with new batteries. Remove old, exhausted batteries immediately.
23
Replace the coverSlide off the battery coverInsert batteries --- note correct polarity
D Do not mix different battery types, i.e. Alkaline and Manganese. Do not use rechargeable (Ni---Cad) batteries.
4
INSTALLATION AND SET---UP
1
TV only
Connect Aerial co---axial cable direct
to TV RF IN socket.
OR
USING A VCR
Connect aerial co ---axial cable to RF Input socket of
VCR and a RF co--- axial cable from VCR RF Out
socket to TV RF IN socket.
TheVCRcanalsobeconnectedtotheTVusinga
SCART to SCART lead.
VCR
Further details of Audio/ Video connections
Ancillary equipment and leads are not supplied.
can be found on page 11.
2
Switch ON your VCR. *
Plug the TV into a mains socket and switch ON.
Programmes will appear immediately if your dealer
has programmed the TV for you.
1
*1We recommend that you switch ON the VCR’s test signal --- refer to your VCR instruction book.
5
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.