PANASONIC PV-DC3000 SCHEMATIC DIAGRAMS sc1 note

1. Important safety notice
Components identified by the sign

have special
characteristics important for safety. When replacing any
of these components. Use only the specified parts.

2. Do not use the part number shown on this drawing for ordering.
The correct part number and part value is shown in the parts list, and may be slightly different or amended since this drawing
was prepared.

3. Use only original replacement parts:
To maintain original function and reliability of repaired units, use only original replacement parts which are listed with their
part numbers in the parts list section of the service manual.

4. Parts different in shape or size may be used.
However, only interchangeable parts will be supplied as service replacement parts.

5. Test point information

:Test point with no test pin.

Schematic Diagram Notes

1. Indication for Zener Voltage of Zener Diodes
The Zener Voltage of Zener Diodes are indicated as such on Schematic Diagrams.

Example:

(6.2V)......Zener Voltage

3. Parts enclosed in dashed lines marked "Z" are not used in any models included in this service manual.
Example:

R937

47K

D905

Z

4. The part number shown on this drawing is only main part number,

except for safety parts. Be sure to make your orders of replacement parts according to the parts list.

Signal Waveform Note

How to read Signal Waveform

6

1

WF6

PIN60 OF P3

0.2V

2

V1 0.6Vp-p

5

PB
20µs

4

3

1 Connecting Point
2 Volts/Div
3 Volts/Div
4 Connecting Point
5 Time/Div
6 Trigger Channel of

the scope
(1:CH1,2:CH2)
7 Operation Mode of

VCR
8 Waveform Point on

Schematic
9

∆

V1:Peak to Peak

2. How to identify Connectors
Each connector is labeled with a Connector No. and Pin No. Indicating what it is connected to,

in other words, its counter part.

Use the interconnection schematic diagram to find the connection between associated connectors.

Example:
The connections between C.B.A.s are shown below.

Ref. No. of the connection parts such as lead cable,
flexible cable which is supplied as a replacement parts.

The Number of pins of the Connector.

AUDIO CONTROL
HEAD UNIT

MAIN C.B.A.

P4092 P4091

P4091 (4 Pins)

Connector No. on Main C.B.A.

Voltage Chart Note

Voltage Measurement

a. Color bar signal in SP mode.
b. ---:Unmeasurable or not necessary to measure.

Circuit Board Layout Note

Circuit Board Layout shows components installed for various models.
For proper parts content for the model you are servicing,
please refer to the schematic diagram and parts list.

NOTE:
Circuit Board Layout includes components which are not used.