Panasonic PT-D3500 User Manual
Panasonic Projectors RS-232C Control Specifications
D-Sub 9-pin (female),
external appearance
Serial input terminal
Pin No.
Signal name
TXD
RXD
GND
CTS
RTS
Description
NC
Send data
Receive data
Connected internally
Ground
NC
Connected internally
NC
D-Sub 9-pin (male),
external appearance
Serial output terminal
Pin No.
Signal name
RXD
TXD
GND
RTS
CTS
Description
NC
Receive data
Send data
NC
Ground
NC
Connected internally
NC
Signal level
Synchronization method
Baud rate
Parity
Character length
Stop bit
X parameter
S parameter
RS-232C-compliant
Start-stop synchronization
9 600bps
None
8 bits
1 bit
None
None
PT-D7700/PT-DW7000 PT-D3500
The main unit is equipped with SERIAL terminals located in its terminal section on the side, and this terminal is
compliant with RS-232C.
Pin assignments and signal names
Communication conditions (Factory setting)
Basic format
Transmission from the computer begins with STX, then the ID, command, parameter, and ETX are sent in this
order. Add parameters according to the details of control.
STX C1 C2 C3 : P1 P2 Pn ETXA D I 1 I 2 ;
Two ID characters
Start
(2 bytes)
ZZ, 1 to 64 and 0A to 0Z
ID designate
Semicolon
3 command
characters (3 bytes)
Colon
Parameter
(undefined length)
End
Attention
Note
No command can be sent or received for 10 to 60 seconds after the lamp starts lighting. Try
sending any command after that period has elapsed.
When sending several commands, be sure to wait for more than 0.5 seconds after receiving a
response from the projector, and then send the next command.
When sending commands without parameters, a colon (:) is not necessary.
If a wrong command is received, the projector will send an ER401 or ER402 command to the computer.
Projector ID supported on the RS-232C interface is ZZ (ALL) and a group of 1 to 64 and 0A to 0Z.
If a command is sent with a projector ID specified, the projector will return answer back only in the
following cases:
If it coincides with the projector ID,
ID specification is ALL and VPS-SYSTEM is the master, or
ID specification is group and Group is the master.
1
Control commands
Item Command:Parameter Function Call Back D7700/DW7000 D3500 Remarks
POWER PON POWER ON PON YES YES
POF STANDBY(POWER OFF) POF YES YES
FREEZE OFZ:0 FREEZE OFF OFZ:0 YES YES
OFZ:1 FREEZE ON OFZ:1 YES YES
AUTO SETUP OAS AUTO SETUP OAS YES YES
SHUTTER OSH:0 SHUTTER OFF OSH:0 YES YES
OSH:1 SHUTTER ON OSH:1 YES YES
INPUT SELECT IIS:RG1 RGB-1 IIS:RG1 YES YES
IIS:RG2 RGB-2 IIS:RG2 YES YES
IIS:VID VIDEO IIS:VID YES YES
IIS:SVD S-VIDEO IIS:SVD YES YES
IIS:DVI DVI IIS:DVI NO YES
IIS:AUX AUX IIS:AUX YES NO
IIS:AUX,AW1 AUX LINE(Only MD95VM2) IIS:AUX,AW1 YES NO
IIS:AUX,AW2 AUX Y/C (Only MD95VM2) IIS:AUX,AW2 YES NO
TEST OTS:00 EXIT Test Pattern OTS:00 YES YES
OTS:01 WHITE OTS:01 YES YES
OTS:02 BLACK OTS:02 YES YES
OTS:03 CHECKER1 OTS:03 YES YES
OTS:04 CHECKER2 OTS:04 YES NO
OTS:05 1% WHITE WINDOW OTS:05 YES YES
OTS:06 1% BLACK WINDOW OTS:06 YES YES
OTS:07 CROSS HATCH OTS:07 YES YES
OTS:08 COLOR BAR OTS:08 YES YES
OTS:09 RAMP OTS:09 NO YES
ON SCREEN OOS:0 OSD OFF OOS:0 YES YES
OOS:1 OSD ON OOS:1 YES YES
MUTE AMT:0 AUDIO MUTE OFF AMT:0 NO YES
AMT:1 AUDIO MUTE ON AMT:1 NO YES
Adjustment Mode
Item Command:Parameter Function Call Back D7700/DW7000 D3500 Remarks
PICTURE MODE VPM:NAT NATURAL VPM:NAT YES YES
VPM:STD STANDARD VPM:STD YES YES
VPM:DYN DYNAMI VPM:DYN YES YES
VPM:CIN CINEMA VPM:CIN YES YES
VPM:GRA GRAPHIC VPM:GRA YES YES
COLOR VCO:p1p2p3 COLOR Value Adjust VCO:p1p2p3 YES YES From0 To 100 *1
TINT VTN:p1p2p3 TINT Value Adjust VTN:p1p2p3 YES YES From0 To 62 *3
COLOR TEMP. OTE:0 LOW OTE:0 YES NO
OTE:1 MIDDLE OTE:1 YES YES
OTE:2 HIGH OTE:2 YES YES
OTE:4 USER (USER1) OTE:4 NO YES
OTE:9 USER2 OTE:9 YES NO
OTE:10 DEFAULT OTE:10 YES YES
CONTRAST VCN:p1p2p3 CONTARST Value Adjust VCN:p1p2p3 YES YES From0 To 63 *1
BRIGHTNESS VBR:p1p2p3 BRIGHTNESS Value Adjust VBR:p1p2p3 YES YES From0 To 63 *1
SHARPNESS VSR:p1p2p3 SHARPNESS Value Adjust VSR:p1p2p3 YES YES <SD> From0 To 15,
<HD,RGB>From0 To 7 *1
SET DATE TSD:y1y2y3y4m1m2d1d2w Set Date
SET TIME TST:h1h2m1m2s1s2 Set Time TST:h1h2m1m2s1s2 YES YES *2
VOLUME AVL:p1p2p3 AUDIO VOLUME AVL:p1p2p3 NO YES
*1: Regarding p1p2p3, +1,+01,+001,1,01,001 are All Accepted *2: Date/Time Should be set on UTC (Coordinate Universal Time)
TSD:y1y2y3y4m1m2d1d2w
YES YES y1y2y3y4m1m2d1d2+Date of Week
Mon=1,Tue=2,
NO YES
...
,Sun=7 *2
2
Status Asking Comman
Item Command:Parameter Function Call Back D7700/DW7000 D3500 Meaning Remarks
POWER CONDITION
FREEZE QFZ Freeze Function Status 0 YES YES OFF
SHUTTER QSH Shutter Status 0 YES YES OFF
INPUT SIGNAL QIN Input Signal Status RG1 YES YES RGB1
TEST QTS Test Pattern Status 00 YES YES EXIT Test Pattern
02 YES YES BLACK
ON SCREEN QOS ON SCREEN Status 0 YES YES off
PICTURE MODE QPM PICTURE MODE Status NAT YES YES NATURAL
COLOR QVC COLOR Adjust Value Check p1p2p3 YES YES
TINT QVT TINT Adjust Value Check p1p2p3 YES YES
COLOR TEMP. QTE COLOR TEMP Status Check 0 YES NO LOW
CONTRAST QVR
BRIGHTNESS QVB BRIGHTNES Adjust Value p1p2p3 YES YES
SHARPNESS QVS SHARPNESS Adjust Value p1p2p3 YES YES
SET RUNTIME QST Set Run Time CHeck p1p2p3p4p5 YES ES 00000h~99999h
LAMP ON TIME Q$L:1 LAMP1 Run Time Check p1p2p3p4 YES YES 0000h~9999h
LAMP SELECT QSL Lamp Operation Mode Check 0 YES NO DUAL
LAMP POWER QLP LAMP POWER Mode Check 0 YES YES HIGH
VPS SYSTEM QVY VPS SYSTEM Check 0 YES NO SLAVE
QPW Main Power Status 000 YES YES STANDBY(OFF)
001 YES YES ON
1 YES YES ON
1 YES YES ON
RG2 YES YES RGB2
VID YES YES VIDEO
SVDYES YES YES S-VIDEO
DVI NO YES DVI
AUX YES NO AUX
QIN:AW AUX,AW1 YES NO AUX LINE MD95VM2
QIN:AW AUX,AW2 YES NO AUX Y/C MD95VM2
01 YES YES WHITE
03 YES YES CHECKER1
04 YES NO CHECKER2
05 YES YES 1% WHITE WINDOW
06 YES YES 1% BLACK WINDOW
07 YES YES CROSS HATCH
08 YES YES COLOR BAR
09 NO YES RAMP
1 YES YES on
STD YES YES STANDARD
DYN YES YES DYNAMIC
CIN YES YES CINEMA
GRA YES YES GRAPHIC
1 YES YES MIDDLE
2 YES YES HIGH
4 YES YES USER (USER1)
9 YES NO USER2
10 YES YES DEFAULT
CONTARST Adjust Value Checking
Q$L:2 LAMP2 Run Time Check p1p2p3p4 YES NO
p1p2p3 YES YES
1 YES NO SINGLE
2 YES NO LAMP1
3 YES NO LAMP2
1 YES YES LOW
2 TBD YES (RESERVED)
1 YES NO MASTER
3
Loading...