Panasonic NN-ST785S Installation Guide

Installation Instructions

Trim kit

24”cabinet

(596 mm)

TK712SSQP

TK712SWQP

Contents

Attention .............................................................................................................................................P1

Step 1. Unpacking list .........................................................................................................................P2

Step 2. Feature diagram .....................................................................................................................P3

Step 3. Cabinet Preparation ...............................................................................................................P4

Step 4. Microwave Oven Installation ..................................................................................................P5

Step 5. Cabinet Installation............................................................................................................. P6-7

Step 6. Finishing Installation......................................................................................................... P8-10

1. This trim kit can be installed into a cabinet.The cabinet opening must have the following internal dimensions as shown in ﬁg 1, p 4.

A vent is required at the rear of the cabinet. It should travel the full height of the cabinet and the

cabinet should not be obstructed. Minimum dimension of vent: 45 mm x 600 mm (ﬁg 1, p 4).

MINIMUM INSTALLATION HEIGHT 850 MM.

2. Electrical Connections The appliance is supplied with a mains plug attached and should only be connected into an earthed socket that has been installed according to the relevant safety regulations. If the plug is no longer accessible after the appliance has been built into the cabinet, a dual pole isolator must be installed to conform to the relevant safety standards.

3. Appliance shall be provided with means for disconnection from the supply mains having a contact separation in all poles that provide full disconnection under overvoltage must be incorporated in the ﬁxed wiring in accordance with the wiring rules and accessible.

4. It is essential that the cabinet is ﬁxed to the wall for stability. The shelf must be able to support a weight of 30 kg.

5. If the microwave oven is to be removed from the kitchen cabinet and used free standing, the built in parts must be removed, and the oven returned to its original condition. Keep these installation instructions for future reference so the installation process can be reversed.

Ⅲ conditions, such means

TAKE CARE NOT TO KINK OR TRAP THE MICROWAVE ELECTRICAL CABLE.

The diagram may vary from the actual unit and is only for your reference.

Step 1. Unpacking list

Tools Needed

• Measuring tape

• Pencil

• Driver

• Ø2 drill

Parts Supplied

PART QUANTITY

Trim Frame 1

Left Duct 1

Rail 2

Bracket 4

Catch 4

Tape 2

Screw 12

Strike 4

Step 2. Feature diagram

Installed Image

Trim kit Dimensions

Width 596 mm

Height 410 mm

Depth 20 mm (Thickness)

+ 8 hidden pages