Panasonic lns10, lns-t10, lns-w10, lns-t11, lns-w11 Operation Manual
After the lens replacement (before attaching the top cabinet), check the following
things.
1. Check the lens is properly installed.
2. Check no wiring is tangled on the gear of the lens motor or other mechanical
parts.
3. Check no parts is missing, or no mounting part is lost.
LCD Projector
Lens Replacement Procedure
Model Number
1AA6P1P5436-- (IFGP)
LNS-S10/LNS-T10/LNS-W10/LNS-T11/LNS-W11
Lens replacement should be performed by the qualified service
personnel.
It should be followed by this procedure precisely.
Before an attempt to replace the lens, confirm the model number
(both the LCD projector and the lens) and prepare the proper lens.
Lens installation is different in cabinet design (Type A and B).
Before installing the lens, check cabinet design should be made.
The lens cover is on the lens for protection. Be sure to remove the
lens cover before installation.
Please avoid the lens replace in the place where a lot of dust
exists. It causes the image quality to be ruined when garbage and
dust enter the projector.
When installing or removing the lens, be careful not to stain,
scratch or damage the lens.
If you have any questions, contact the dealers.
Notes on Lens Replacement
Following parts are contained in the packing.
● LENS
● LIGHT-BLOCK SHEET (Spare)
(Except LNS-W11)
1 piece
1 piece (Part No. 910 322 9677)
Notes on Lens Replacement
Parts List
Printed in Japan
-2-
Lens Replacement Procedure
While pressing the Lens release button on the top of
the cabinet, turn the lens counterclockwise until it
stops and pull it out slowly from the projector.
Be careful not to drop the lens.
Remove the Lens
1
2
Perform the steps 1-2 for lens replacement.
First set the lens at the center position with lens shift adjustment.
Fig-1-1
LENS RELEASE BUTTON
Fig-1-2
Fig-2
Red mark
(For A type Cabinet)
Mount the Lens
1. Remove the protective caps (front and back) on the lens.
2. Insert the lens into the Lens Bracket of the projector as
matching the red mark on the lens to that on the Lens
Bracket.
3. Slowly turn the lens clockwise until it clicks. Make sure that
the lens is fully inserted to the projector.
Loading...