Minimum Space and Installing the Stand ...............................................................................................8
• Minimum space ........................................................................................................................................8
• Installing the stand ...................................................................................................................................8
Installing the Document Tray and the Exit Tray .....................................................................................9
Loading a Document............................................................................................................................ 10
Clearing Paper Jams ........................................................................................................................... 12
Cleaning the Unit ................................................................................................................................. 13
Index .................................................................................................................................................... 18
The information given in this Operation Manual is subject to change without notice.
This Operation Manual is printed on recycled paper.
Notice
_______________________________
^ Federal Communications Commission Requirements ^
(For United States only)
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursu
ant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harm
ful interference when the equipment is operated in a commercial environment This equipment
generates, use, and can radiate radio frequency energy and, if not installed and used accordance with
the instruction manual; may cause harmful interference to radio communications. Operation of this equip
ment in a residential area is likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
FCC Warning: To assure continued FCC compliance, the user must use only the provided power supply
cord and shielded interface cable. Also, any unauthorized changes or modifications to this equipment
would void the user's authority to operate this device.
English
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT TO RAIN
OR ANY TYPE OF MOISTURE.________________________________________________■
THE SOCKET OUTLET MUST BE NEAR THIS EQUIPMENT AND MUST BE EASILY AC
CESSIBLE.
Français
Avertissement:
Pour éviter tout risque d'incendie ou de choc électrique, ne pas soumettre cet appareil
à la pluie ou à rhumidité.
"La prise secteur devra se trouver à proximité de l'appareil et être facilement
accessible."
Zur Verhütung von Feuer dem und elektrischem Schlag dieses Erzeugnis nicht Regen
oder sonstiger Feuchtigkeit aussetzen.
Die Steckdose muß nahe bei diesem Gerät angebracht und leicht zugänglich sein.
L.
Für Benutzer in der BRD
Hinweis:
Der arbeitsplatzbezogene Geräuschemissionswert dieses Gerätes beträgt < 70 dB(A)
nach DIN 45635 Teil 19.
Notice
For your safety please read the following text carefully.
(For United Kingdom only)
This appliance is supplied with a moulded three pin mains plug for your safety and convenience.
A5 amp. fuse is fitted in this plug. Should the fuse need to be replaced please ensure that the replacement
fuse has a rating of 5 amps, and that it is approved by ASTA or BSI to BS1362. Check for the ASTA mark
or the BSI mark ^on the body of the fuse. If the plug contains a removable fuse cover you must ensure that
it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replace
ment cover is obtained. A replacement fuse cover can be purchased from your local Panasonic Dealer.
If the fitted moulded plug is unsuitable for the socket outlet in your home then the fuse should be removed
and the plug cut off and disposed of safely.
There is danger of severe electrical shock if the cut off plug is inserted into any 13 amp. socket.
If a new plug is to be fitted please observe the wiring code as shown below. If in any doubt please consult a quali
fied electrician.
WARNING : This appliance must be earthed.
IMPORTANT: The wires in this mains lead are coloured in accordance with the following code.
Green-and-Yellow : Earth
Blue : Neutral
Brown : Live
As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows.
The wire which is coloured Green-and-Yellow must be connected to the terminal in the plug which is marked
with the letter E or by the Earth symbol or coloured Green-and-Yellow.
The wire which is coloured Blue must be connected to the terminal in the plug which is marked with the letter
N or coloured Black.
The wire which is coloured Brown must be connected to the terminal in the plug which is marked with the let
ter L or coloured Red.
How to replace the fuse :
Open the fuse compartment with a screwdriver and replace
the fuse.
Precautions
The following precautions are recommended to extend the life of the unit
Do not place any liquids near the unit
— Accidental spillage of a liquid into the unit may
cause severe damage If this occurs, unplug the
power cord and call service
Do not operate the unit with covers open
0
Do not place books, paper, or other items on the
unit
0
If the unit IS not used for an extended period, un
plug the power cord
0
Do not place the unit on an uneven or unstable sur
face
The unit must remain in a vertical position
0
0
Special care should be taken to protect the unit if it is used in a less than optimum environment such as a ma
chine shop or a dusty or sandy area
Precautions
Operating Environment
Do not subject the unit the following conditions.
Do not place the unit in direct sunlight or in a cold
draft.
0
Do not place the unit near a heating appliance or
an air conditioning vent. Do not place the unit in a
room with extremely high or low humidity.
0
Do not place the unit in an area where there is a
lot of smoke, dust, chemical fumes or vibration.
Thinner, etc.
Do not place the unit near other appliances.
0
Do not place the unit on a carpet. (Static electricity
can cause the unit to malfunction)
Do not disassemble the unit.
0
Power Source
• Use a voltage level which does not vary more than ± 10% from the voltage level marked on the name
plate (located on the rear of the scanner).
• Do not use an extension cord.
• This scanner should be connected to a grounded outlet.
• Do not use a line conditioner, transient suppressor or surge protector.
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.