Panasonic ET-SFD100 Installation Instruction

Installation Instructions

Smoke-cut filter for DLP® Based Projectors

Model No.

Thank you for choosing the smoke-cut filter for Panasonic DLP® Based Projectors.

Only a qualified installer should install this product.

■

Read these instructions completely before installing this product.

ET-SFD100

Precautions with regard to safety

CAUTION

This filter can be used for approximately 24 hours in smoky environments. If it is used

■

for more than approximately 24 hours, operating problems may occur.

Do not wash the smoke-cut filter with water.

■

Do not reuse.

■

Do not use the filter at high altitudes (1 400 m or more above sea level) or in places where the ambient temperature is 35 °C or higher.

Installing the smoke-cut filter

Installation procedure

1. Turn off the main power and remove the power plug from the receptacle.

Be sure to observe the procedure “Powering off the projector” of the projector’s Operating Instructions and

•

Be sure to observe the procedure “Powering off the projector” of the projector’s Operating Instructions and

• then remove the power plug.

then remove the power plug.

2. Use a Phillips screwdriver to

2. Use a Phillips screwdriver to loosen the filter cleaning unit

loosen the filter cleaning unit fixing screw at the front of the

fixing screw at the front of the projector.

projector.

Insert your hand into the base of the air filter and

•

Insert your hand into the base of the air filter and

•

pull the air filter forwards while removing the filter

pull the air filter forwards while removing the filter cleaning unit from the projector.

cleaning unit from the projector.

Filter cleaning

Filter cleaning unit

unit

3. Insert the smoke-cut filter

3. Insert the smoke-cut filter securely into the projector as

securely into the projector as far as it will go, and then use a

far as it will go, and then use a Phillips screwdriver to securely

Phillips screwdriver to securely tighten the fixing screw.

tighten the fixing screw.

4. Turn on the power for the

4. Turn on the power for the projector.

projector.

Carry out the steps in “Changing the fan mode”

•

Carry out the steps in “Changing the fan mode”

•

on the next page.

Attention

The air filter must be installed before using the

•

The air filter must be installed before using the

•

projector. If the projector is used without the air

projector. If the projector is used without the air filter installed or if it is not inserted securely into the

filter installed or if it is not inserted securely into the projector as far as it will go, foreign particles and dust

projector as far as it will go, foreign particles and dust will get inside the projector and cause problems with

will get inside the projector and cause problems with operation.

operation.

Filter cleaning unit fixing screw

Front cover

Front cover fixing screw

Smoke-cut filter

Note

This filter can be used for approximately 24 hours in smoky environments. If it is used for more than

• approximately 24 hours, operating problems may occur.

Do not wash the static electric mesh filter with water.

• Do not reuse.

• This filter will not remove 100 % of the smoke from the air. If the projector is used repeatedly in a smoky

• environment, it may require inspection or repairs.

+ 2 hidden pages