Panasonic ES-LF51-A, ES‑LF51 Operating Instructions Manual
Operating Instructions
Manuel d’utilisation
Manual De Operación
(Household)
Rechargeable Shaver
(Utilisation domestique)
Rasoir rechargeable
(Uso doméstico)
Afeitadora Recargable
Model No. ES‑LF51
N
o
de modèle ES‑LF51
Modelo No. ES‑LF51
English 2
Français 9
Español 16
Before operating this unit, please read these instructions completely and save them for future use.
Avant d’utiliser ce produit, veuillez lire attentivement les instructions et conserver ce manuel pour un usage futur.
Antes de utilizar este producto, lea las instrucciones detenidamente y guarde este manual para uso futuro.
ES-LF51_US.indb 1 2011/04/26 10:51:59
2
English
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic
precautions should always be followed, including
the following:
Read all instructions before using this appliance.
DANGER
To reduce the risk of electric
shock:
1. Do not reach for an appliance that has fallen
into water. Unplug immediately.
2. Charger unit is not for immersion or for use in
shower.
3. Do not place or store appliance where it can fall
or be pulled into a tub or sink. Do not place in
or drop into water or other liquid.
4. Except when charging, always unplug this
appliance from the electrical outlet immediately
after using.
5. Unplug this appliance before cleaning.
6. Do not use an extension cord with this
appliance.
WARNING
To reduce the risk of burns, fire,
electric shock, or injury to persons:
1. Close supervision is necessary when this
appliance is used by, on, or near children or
invalids.
2. Use this appliance only for its intended use as
described in this manual. Do not use
attachments not recommended by the
manufacturer.
3. Ne
ver operate this appliance if it has a
damaged cord or plug, if it is not working
properly, if it has been dropped or damaged, or
dropped into water. Return the appliance to a
service center for examination and repair.
4. Keep the cord away from heated surfaces.
5. Never drop or insert any object into any
opening.
6. Do not use outdoors or operate where aerosol
(spray) products are being used or where
oxygen is being administered.
7. Do not use this appliance with damaged
shaving blades and/or foil, as it has the
potential to result in facial injury.
8. Always attach plug to appliance first, then to
outlet. To disconnect, turn all controls to “off”
then remove plug from outlet.
SAVE THESE INSTRUCTIONS
ES-LF51_US.indb 2 2011/04/26 10:51:59
3
English
Thank you for choosing a Panasonic shaver ES‑LF51. With
our WET/DRY technology, you can enjoy using your
Panasonic shaver dry or in the shower or bath for gentle
and easy shaving. Please read all instructions before use.
Important
This shaver has a built‑in rechargeable battery. Do not throw into
fire, apply heat, or charge, use, or leave in a high temperature
environment.
Before use
This WET/DRY shaver can be used for wet shaving using
shaving lather or for dry shaving. You can use this watertight
shaver in the shower and clean with water. The following symbol
means suitable for use in a bath or shower.
Treat yourself to wet lather shaves for at least three weeks and
notice the difference. Your Panasonic WET/DRY shaver requires
a little time to get used to because your skin and beard need
about a month to adjust to any new shaving method.
Using the shaver
Caution
The outer foil is very thin and can be damaged if not used
correctly. Check that the foil is not damaged before using
the shaver. Do not use the shaver if the foil is damaged as
you will cut your skin.
Terminate the usage when there is an abnormality or failure.
Do not share your shaver with your family or other people.
Doing so may result in infection or inflammation.
•
•
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the
appliance by a person responsible for their safety. Children
should be supervised to ensure that they do not play with the
appliance.
Char
ging the shaver
Never use the AC adaptor in the bathroom or shower room.
Do not use any power cord or AC adaptor other than the AC
adaptor (RE7‑59).
Plug in the AC adaptor into a household outlet where there is
no moisture and handle it with dry hands.
Hold the AC adaptor when disconnecting it from the household
outlet. If you tug on the power cord, you may damage it.
The supply cord cannot be replaced. If the cord is damaged,
the AC adaptor should be scrapped.
The AC adaptor is intended to be correctly oriented in a
vertical or floor mount position.
Cleaning
the shaver
Warning
Disconnect the power cord from the shaver before
cleaning it in water to prevent electric shock.
Keep both the inner blades inserted. If only one of the inner
blades is inserted, the shaver may be damaged.
If you clean the shaver with water, do not use salt water or hot
water. Do not soak the shaver in water for a long period of
time.
Clean the housing only with a soft cloth slightly dampened
with tap water or soapy tap water. Do not use thinner, benzine,
alcohol or other chemicals.
•
•
•
•
•
•
•
•
•
•
ES-LF51_US.indb 3 2011/04/26 10:51:59
4
English
Storing the shaver
Store the shaver in a place with low humidity after use.
Do not store the shaver where it will be exposed to direct
sunlight or other heat sources.
Disconnect the power cord when storing the shaver.
Do not bend the power cord or wrap it around the shaver.
Parts identification
A Protective cap
B Outer foil section
1 Foil frame
2 System outer foil
3 System outer foil release
buttons
C Inner blades
D Main body
4 Foil frame release buttons
5 Pivot action selector
6 Lock ring
7 Battery capacity lamp
8 Charge status lamp ( )
9 Appliance socket
•
•
•
•
: P
ower switch [0/1]
; Thumb rest
< Trimmer
= Trimmer handle
E AC adaptor (RE7‑59)
> Power cord
Appliance plug
F Travel case
Using the lock ring
Use the lock ring to lock or unlock the power switch.
Rotate the lock ring until it clicks.
Rotate the lock ring to “ ” to unlock the power
switch:
For when shaving, washing the shaver, lubricating
the shaver.
Rotate the lock ring to “ ” to lock the power
switch:
For when carrying the shaver.
Charge
Charging the shaver
1
1
Insert the appliance plug into the
shaver.
2
2
Plug in the AC adaptor into a
household outlet.
Turn the shaver off before attaching.
Charging is completed after approx. 1 hour.
If the shape of the plug does not fit the power outlet, use an
attachment plug adaptor of the proper configuration.
You cannot operate the shaver while charging.
•
•
•
ES-LF51_US.indb 4 2011/04/26 10:51:59
5
English
Reading lamps when charging
While charging After charging is completed
The charge status lamp ( ) glows.
The number of the battery
capacity lamp will increase as
charging progresses.
All the lamps will light up and
then turn off after 5 seconds.
After charging is completed, turning the power switch ON with
the shaver plugged in will cause all the lamps to light up and then
turn off after 5 seconds. This shows that the shaver is fully
charged.
Recommended ambient temper
ature for charging is 5‑35 °C
(41‑95 °F). The battery may not charge properly or not at all
under extreme low or high temperatures.
The charge status lamp ( ) will blink when there is a problem
with charging.
When charging the shaver for the first time or when it has not
been in use for more than 6 months, the charge status lamp ( )
may not glow. It will eventually glow if kept connected.
•
•
•
Shave
Using the shaver
1
1
Rotate the lock ring to
unlock the power switch
and press the power
switch.
Page 4
2
2
Hold the shaver
as illustrated
above and shave.
We recommend using the shaver in an ambient temperature
range of 5 ‑ 35 °C (41 ‑ 95 °F). If used outside this range, the
appliance may stop operating.
Start out shaving by applying gentle pressure to your face.
Stretch your skin with your free hand and move the shaver back
and forth in the direction of your beard. You may gently increase
the amount of pressure as your skin becomes accustomed to
this shaver. Applying excessive pressure does not provide a
closer shave.
Caution
If you press the power switch for more than 2 seconds, the
sonic vibration cleaning mode is activated.
Page 6
You cannot shave in this mode.
Do not place your fingers on the power switch while using the
shaver. This may cause the shaver to turn off or enter the sonic
vibration cleaning mode. Place your thumb on the thumb rest
while using the shaver.
•
•
•
ES-LF51_US.indb 5 2011/04/26 10:52:00
6
English
Pivot action selector
Use to select “SOFT” (soft) or “LOCK”
(lock).
You can change the pivot action whether
the shaver is turned on or off.
Using the trimmer
Slide the trimmer handle up. Place
at a right angle to your skin and
move downwards to trim your
sideburns.
Reading lamps when using
While using
Approximate amount of battery charge is
displayed as 20 ‑ 100.
•
It will turn off approximately 5 seconds after operating the switch.
•
When the battery capacity is low
“20” blinks when operating the shaver.
You can shave 2 to 3 times after “20” appears. (This will differ
depending on usage.)
A full charge will supply enough power for approx. 14 shaves of
3 minutes each. (This will differ depending on usage.)
•
•
Clean
Cleaning the shaver
1. Disconnect the power cord from the shaver.
2. Apply some hand soap and some water to
the outer foil.
3. Rotate the lock ring to unlock the power
switch.
4. Press the power switch for more than 2
seconds to activate the sonic vibration
cleaning mode.
The battery capacity lamps blink in order.
After about 20 seconds, it will be
automatically turned off, or you can turn it
off by pressing the power switch.
5. Remove the outer foil section and press the
power switch for more than 2 seconds to
activate the sonic vibration cleaning mode
and clean it with running water.
6. Wipe off any drops of water with a dry cloth.
7. Dry the outer foil section and the shaver
completely.
8. Attach the outer foil section to the shaver.
•
•
4
5
ES-LF51_US.indb 6 2011/04/26 10:52:01
7
English
Replacing the system outer foil and the inner blades
system outer foil once every year
inner blades once every two years
Replacing the system outer foil
1. Press the foil frame release buttons and lift
the outer foil section upwards.
2. Press the system outer foil release buttons
and pull down the system outer foil.
3. Align the foil frame mark ( ) and the
system outer foil mark ( ) and securely
attach together.
The system outer foil cannot be reversely
attached.
Always insert the system outer foil to the
foil frame when attaching to the shaver.
4. After turning the foil frame mark ( ) to the
front, securely attach the outer foil section to
the shaver until it clicks.
•
•
Replacing the inner blades
1. Press the foil frame release buttons and lift
the outer foil section upwards.
2. Remove the inner blades one at a time.
Do not touch the edges (metal parts) of
the inner blades to prevent injury to your
hand.
3. Insert the inner blades one at a time until
they click.
•
Replacement
parts
Replacement parts are available at your dealer or Service Center.
Replacement parts for
ES‑LF51
System outer foil and inner
blades
WES90
27
System outer foil WES9167
Inner blades WES9068
Removing the built‑in rechargeable battery
ATTENTION:
A lithium ion battery that is recyclable powers the product you
have purchased. Please call 1‑800‑8‑BATTERY for information
on how to recycle this battery.
Remove the built‑in rechargeable battery before disposing of the
shaver. Do not dismantle or replace the battery so that you can
use the shaver again. This could cause fire or an electric shock.
Please contact an authorised service center.
The battery replacing service is available only in the United States
of America.
Disconnect the power cord from the shaver when removing the
battery.
•
ES-LF51_US.indb 7 2011/04/26 10:52:01
8
English
Perform steps 1 to 9 and lift the battery, and then remove it.
Specifications
Power source
See the name plate on the AC adaptor.
(Automatic voltage conversion)
Motor voltage
3.6 V
Charging time Approx. 1 hour
This product is intended for household use only.
•
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, install and use in
accordance with provided instructions. Any changes or
modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this
equipment.
•
•
•
•
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
FOR YOUR CONVENIENCE, WE HAVE ESTABLISHED A
TOLL‑FREE (IN USA ONLY) NATIONAL ACCESSORY
PURCHASE HOT LINE AT 1‑800‑332‑5368.
IN CANADA, CONTACT PANASONIC CANADA INC. AT THE
ADDRESS OR TELEPHONE NUMBER ON THE BACK PAGE.
ES-LF51_US.indb 8 2011/04/26 10:52:02
Loading...