Panasonic CT-32G5, CT-27G5, CT-2014S Owner’s Manual

YournewTVMonitor/Receiverfeatures a solid

state chassis that is designed to give you many years of enjoyment. It was thoroughly tested and tuned at the factory for best performance.

Customer Record

The model and serial number of this product may be found on the back of the unit. You should note

the model and serial number in the space provided

and retain as a permanent record of your purchase. This will aid in identification in the event

of theft or loss

Product registration is available for U.S customers at:

www.pr odreg.con'dpan asonic

Model Number

Serial Number

Care and Cleaning

Screen (Turn TV Off)

Use a mild soap solution or window cleaner with a sofl clean cloth, DO NOT USE ABRASIVE CLEANERS.

Avoid excessive moisture and wipe dry.

Note: Do not spray any type of cleaning fluid

directly on the screen.

Cabinet and Remote Control

Use a soft cloth dampened with water or a mild detergent solution. Do not use

benzene, thinner, or other petroleum based c_eaners.

Wipe dry with a soft clean cloth. Avoid excessive moisture.

Specifications

Power Source CT-13R5 (0,gA) CT-25G5

CT-13R31 (0.9A) CT-25G5U CT-13R41 (0.gA) CT-27G5 (1.8A) 120V AC CT-2OD10 (1.4A) CT-27G5U (1,8A) 60Hz CT-20G5 (I.4A) CT-32G5 (Z.0A) CT-20R5 (1.3A) CT-32G5U (2.0A) CT-2014S (1.4A)

Channel Capability - 181 UHF-56

Video Input Jacks 75 Ohm

(some models) Phono Jack

VHF-12

Cable+113

1 Vp_p

Type

Television Location

This unit is intended to be used with an optional stand or entertainment center. Consult your dealer for available options.

O Avoid excessive sunlight or bright lights,

including reflections.

[] Keep away from excessive heat or moisture.

Inadequate ventilation may cause internal component failure.

[] Fluorescent lighting may reduce Remote

Control transmitting range.

[] Avoid magnetic equipment, including motors,

fans, or external speakers.

Optional Cable Connections

Shielded audio and video cables should be used between components. For best results:

Use 75-ohm coaxial shielded cables. Use appropriate input and output

connectors that match your component connectors.

Avoid long cables to minimize interference.

AC Power Supply Cord

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH

WIDE BLADE OF PLUG TO WIDE SLOT OF AC OUTLET

AND FULLY INSERT. DO NOT USE A PLUG WITH A

RECEPTACLE OR OTHER OUTLET UNLESS THE BLADE CAN BE FUL_ iNSERTEDTO PREVENT BLADE EXPOSURE+ FOR SOME MODELSTHAT

ARE NON-POLARIZED, THE USE OF AN AC ADAPTOR CONNECTOR MAY BE NECESSAR_

Polarized plug

Non-Polarized plug

Batteries

Replace batteries in pairs. Do not mix battery types (zinc carbon

with alkaline).

Do not recharge, short-circuit,

disassemble, heat, or burn used

batteries.

Cable / Antenna

For proper reception, either a cable or antenna connection are required.

Cable Connection

Connect the cable supplied by your local cable company.

Incoming Cable from Cable Company

Audio Input Jacks 500mV RMS

(some models) 47K Ohm

To Audio AMP Jack 0-2,0V RMS

(some models) 4.7K Ohm

Specifications are subject to chan< e without notice or obligation.

75 Ohms VHF/UHF

on back of TV

Note: A cable converter box may be required

for proper recepbon. Check with your local Cable company for compatibility requirements.

-2-

Antenna Connection VHF/UHF Antenna o_

For proper reception of VHF/UHF

channels, an external antenna is required. A VHF/UHF antenna and transformer are supplied

For best reception an outdoor antenna is in some models. Attach to the TV, adjust the recommended, antenna until the picture is clear. (See Antenna

Antenna Mode must be set to TV. Connection).

Incoming Cable from Home Antenna

Helpful Hints: Cable Preset

Cable Mode is preset at the factory, Antenna users must change to Antenna Modein theSet Up Menu.

Optional Equipment

Connections

Procedure

1. Connect equipment as shown to front or rear Audio/Video input jacks.

Note: Front and rear Audio/Video

connections cannot be operated at the same time.

2. Select the Video mode by pressing TV/

VIDEO button.

3. Operate optional equipment as instructed

in equipment manual.

Note: VCRs, video disc players, video game

equipment, and OSS equipment can also be connected to the antenna input connection. (See your equipment

manual),

To Audio Amplifier (AMP, some

models)

Connect to an external audio amplifier input for

listening to sound from a stereo system, _

Note: TO AUDIO AMP terminals cannot be used

Audio Adjustments •

Note: In OFF&PAO the volume is controlled by

directly for external speakers (n

1. Press TV SPEAKERS ON button located

on back of set. Note: If your TV does not have a TV

2. Set amplifier volume to minimum. •

3. Adjust TV volume to desired level.

4. Adjust amplifier volume to match the TV.

5. Press TV SPEAKERS OFF button located on back of set. ;_

Note: If your TV does not have a TV

6. Volume and mute are now selected using the TV controls.

the external amplifier. _1

SPEAKERS ON/OFF button, select TV SPEAKERS ON from "_

AUDIO menu.

SPEAKERS ON/OFF button, select OFF&VAO from AUDIO

menu. •

Terminals on back of TV (some models)

R L

R -AUDIO- L

STEREO MODELS

_;_o,o

INpUT

VIDEO _'-,..._.._ (Cables notsupplied)

}

VIDEO L -AUDIO- R

o _o o)

VIDEO L-AUDIO-R

oo o)

Jack used for

1/8" earphone lug

(some m odelPs)

VCR or Video Disc

VmEOOUT_

Terminals on bach of VGR

Terminals on front of TV (some models)

MO.OMODE S(o 0 O)

Jack used for

1/8" earphone lug

(some mode_s)

-3-

VIDEO AUDIO

"10

_o m

-4

ACTION Button

Press the ACTION button to display the Main Menu and submenus. Press tile ACTION button repeatedly

to exit,

Note: Models with no audio features w#l not

display AUDIO Icon in the Main Menu.

Main Menu

I=K4id

Timer

Sleep Timer

In TIMER menu, program to turn TV OFF in 30, 60, or

90 minutes. Select NO to turn off timer

TIMER CONTROL

SLEEP TIMER, NO

PROGRAM TIMER

ON OFF CHANNEL 3

SET TIME FIRST

Program Timer

In Timer menu, program TV to automatically turn on andoff at selected time on a selected channel, dailyor oneday

CH/VOL Buttons

Press the CH (channel) or VOL (volume) buttons to

select an icon. Use the CH buttons to highlight the desired features. Use VOL buttons to select and

adjust features.

Remote Navigation Buttons

VOL O) VOL

Remote Control

The Remote Control Quick Reference Guide is

located in the package provided with the TV.

Languages

In SETUP menu, select ENGLISH, ESPANOL, OR FRAN_AIS.

SET-UP SET TIME _ :

ANT CABLE AUTO PROG NO

MANUAL PROG NO

MODE OFF

ENGLISH ESPAI_OL FRAN(_AIS

TIMER CONTROL

SLEEP TIMER NO

PROGRAM TIMER

ON OFF CHANNEL 3 SET TIME FIRST

Note: TIME must be entered in the SETUP menu

to operate PROGRAM TIMER

Helpful Hints: PROGRAM TIMER

Activation

The PROGRAM TIMER is active when the TV is OFF or ON. The TV will switch to the selected channel at the selected time set by the PROGRAM

TIMER,

Helpful Hints: Turn Off After 90 Minutes

The TV automatically turns OFF after 90 minutes when turned on by the PROGRAM TIMER. If the OFF time is programmed or if a key is pressed, the

automatic OFF after 90 minutes will be cancelled.

CH CAP (Channel Caption)

Program channel captions (station labels) for 30 stations using up to four characters,

CHANNEL CAPTION

ENTER CHANNEL NUMBER 123

ENTER CAPTION

p TO MOVE tu TO SELECT q CURSOR CHANNEL

Note: Delete channel captions by entering dashes

(-) in all four character slots.

-4-

+ 8 hidden pages