Panasonic bl-ca51 Operation Manual

Installation Guide

Wall Mount Cover

Model No. BL-CA51A

A compatible gang box (customer-provided) is needed to use this product. See the Panasonic Network Camera support website at

http://panasonic.co.jp/pcc/products/en/netwkcam/technic/gangbox_info.html for a list of recommended gang boxes.

How to Use This Manual

This manual describes safety instructions, included items, specifications, and how to install this product. The illustrations used in this document are of BL-C111A.

Abbreviation

• “Network Camera” is called “Camera” in this manual.

Consult an authorized dealer for installation. Supported Product (customer-provided)

This product is the dedicated wall mount cover for the cameras and gang boxes listed below. For the latest information, visit the Panasonic Network Camera support website at http://panasonic.co.jp/pcc/products/en/netwkcam/

Compatible Cameras (as of March 2007)

Model No.: BL-C111A, BL-C131A Note

• When using this product with a wireless camera (such as the BL-C131A), communication range and frame rate may be reduced.

Compatible Gang Boxes

Vertically-mounted triple gang box. See the Panasonic Network Camera support website at http://panasonic.co.jp/pcc/products/en/netwkcam/technic/gangbox_info.html for a list of recommended gang boxes.

Additional network camera models and gang boxes may become available for use with this product.

Included Items

The following items are provided.

Wall Mount Cover . .1 pc. Order No.: PQKV10073Z1

Installation Guide (This manual) . . . . . . . . . . . . . . . 1 pc.

PQQX16261ZA KK0307CM0

Mounting Bracket . . 1 pc.

Order No.: PQZMCA51A

Screw A. . . . . . . . . .4 pcs.

Order No.: XTB4+20AFJ

Screw B . . . . . . . . . 2 pcs.

Order No.: XSN3+22FN

Installing this product

When using a wireless camera (such as the BL-C131A)

• A LAN cable does not need to be connected to the camera.

• Refer to the Installation Guide and Setup Guide included with

the camera and confirm that the camera can be accessed wirelessly before following the instructions below.

1. Run the LAN cable and AC adaptor cord through the gang box.

• Use only the AC adaptor included with the camera.

• The cables should extend about 30 cm (1 foot) from the

gang box.

2. Connect the LAN cable and AC adaptor cord to the camera.

• Refer to the Installation Guide included with the camera for

details.

5. Secure the included wall mount cover to the mounting bracket using screws B (included).

Screw B

Wall Mount Cover

3. Secure the included mounting bracket to the camera as shown.

Mounting Bracket

4. Secure the mounting bracket to the gang box (customer-provided) using screws A (included).

Screw A

Specifications

Dimension (WHD) About 136 mm (5 3/8 inches) ×

177 mm (6 15/16 inches) × 59 mm (2 5/16 inches)

Weight About 190 g (0.42 lb.)

* Specifications listed apply to the assembled wall mount cover

and mounting bracket.