Panasonic 9TAWV-TW37003 Users Manual
• Before attempting to connect or install this
product, please read these instructions carefully and save this manual for future use.
• The model number is abbreviated in some
descriptions in this manual.
Operating Instructions
Common Trigger Box
• For information about the installation about
this product, refer to the installation guide
provided by your contact dealer.
Model No.
WV-TW37003P
WARNING:
WV-TW37003
POWER
WIRELESS
Bluetooth
Bluetooth
ANT
ON
OFF
PAIRFD
ON
OFF
CLEAR
RESET
• The installation shall be carried out in accordance with all applicable installation rules.
• The connections should comply with local
electrical code.
•
To prevent fire or electric shock hazard, do
not expose this apparatus to rain or moisture.
• The apparatus should not be exposed to
dripping or splashing and no objects filled
with liquids, such as vases, should be
placed on the apparatus.
CAUTION:
• Changes or modifications not expressly
approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
Preface
• The Common Trigger Box can be installed
in the car. By connecting with Pairing Dock
(option: WV-TW37004), pairing between the
BWC and Common Trigger Box is enabled,
and the BWC can be charged.
•
By connecting the Common Trigger Box
and BWC via Bluetooth
the recording of BWC can be triggered by
external input. Also, the BWC’s operating
information can be informed to the external
devices.
• The Common Trigger Box can be connected
with the existing model SA366 via Wireless
LAN communication.
The model number and serial number of this
product may be found on the surface of the
unit.
You should note the model number and serial
number of this unit in the space provided and
retain this book as a permanent record of your
purchase to aid identification in the event of
theft.
Model No.
Serial No.
®
communication,
For U.S.A
• Power source
To reduce the risk of fire or electric shock and annoying interference, use the recommended
accessory Panasonic MK 3 Lind Distribution Box & Cables only.
Mfr. Part#: ARB-PAPDC2462-3951
• Antenna requirements
Common Trigger Box (WV-TW37003) must be used with following antenna.
ANTENNA PLUS External 2.4 GHz and 5 GHz Wi-Fi antenna: AP-W-Q-S2-RP-BL or ANTENNA
PLUS External 2.4 GHz and 5 GHz Wi-Fi antenna: AP-W-M-S2-RP-WH.
Note:
The 20 cm {7-7/8 inches} minimum separation must be maintained between users and the
antenna. It is desirable that the antenna is located at least 1 m {40 inches} away from other Wi-Fi
antennas to avoid the interference.
For U.S.A.
[Part 15 Subpart C ]
This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment
and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment should be installed
and operated keeping the radiator at least 20cm or more away from person’s body.
[Part 15 Subpart E]
Compliance with FCC requirement 15.407(c)
Data transmission is always initiated by software, which is the passed down through the MAC,
through the digital and analog baseband, and finally to the RF chip. Several special packets are
initiated by the MAC. These are the only ways the digital baseband portion will turn on the RF
transmitter, which it then turns off at the end of the packet. Therefore, the transmitter will be on only
while one of the aforementioned packets is being transmitted. In other words, this device
automatically discontinue transmission in case of either absence of information to transmit or
operational failure.
Frequency Tolerance: ±20 ppm
MEDICAL:
Consult the manufacturer of any personal medical devices, such as pacemakers, to determine if they
are adequately shielded from external RF (radio frequency) energy. (The unit operates in the
frequency range of 2.412 GHz to 2.462 GHz, and the power output level is 0.1 watts.)
Do not use the unit in health care facilities if any regulations posted in the area instruct you not to do
so. Hospitals or health care facilities may be using equipment that could be sensitive to external RF
(radio frequency) energy.
For Canada
[RSS-Gen]
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired opera-
tion of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.
This radio transmitter (IC Number: 216A-WVTW37003) has been approved by Industry Canada to
operate with the antenna types listed below with the maximum permissible gain indicated. Antenna
types not included in this list, having a gain greater than the maximum gain indicated for that type, are
strictly prohibited for use with this device.
Antenna type: AP-W-Q-S2-RP-BL or AP-W-M-S2-RP-WH.
Gain: -0.8dBi (2.4GHz band), -8.1dBi(5GHz band)
Le présent émetteur radio (IC Number: 216A-WVTW37003) a été approuvé par Industrie Canada
pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal.
Les types d'antenne non inclus dans cette liste, et dont le gain est supérieur au gain maximal indiqué,
sont strictement interdits pour l'exploitation de l'émetteur.
Type d’antenne: AP-W-Q-S2-RP-BL or AP-W-M-S2-RP-WH.
Gain: -0.8dBi (2.4GHz bande), -8.1dBi (5GHz bande)
Loading...