Panasonic 96NKX TGHA20, 96NKX TGEA20, 96NKX TGEA20A Users Manual
Installation Manual
Additional Digital Cordless Handset
Model No. KX-TGEA20
KX-TGHA20
KX-TGEA20 KX-TGHA20
Thank you for purchasing a Panasonic product.
This unit is an additional handset compatible with the following series of
Panasonic Digital Cordless Phone:
- KX-TGE210/KX-TGE230/KX-TGE240/KX-TGE260/KX-TGE270 (KX-TGEA20)
- KX-TGH260 (KX-TGHA20)
(The corresponding models are subject to change without notice.)
You must register this handset with your base unit before it can be used. This
installation manual describes only the steps needed to register and begin using
the handset. Please read the base unit’s operating instructions for further details.
Please read this installation manual before using the unit and save it for future
reference.
For assistance, visit our Web site: http://www.panasonic.com/help
for customers in the U.S.A. or Puerto Rico.
Printed in Malaysia
PNQX6369ZA
PT1213MG0
TGEA_TGHA20(en)_1004_ver001.pdf 1 2013/10/04 18:56:56
Accessory information
Supplied accessories
Accessory item/Order number Quantity
Charger
*1
1
AC adaptor/PNLV233Z 1
Rechargeable batteries/HHR-4DPA 2
Handset cover
*2, *3
1
Belt clip (KX-TGEA20)
*4
1
*1 KX-TGEA20: PNLC1050ZB
KX-TGHA20: PNLC1051ZB
*2 The handset cover comes attached to the handset.
*3 KX-TGEA20: PNYNTGEA20BR (Black), PNYNTGEA20SR (Silver)
KX-TGHA20: PNYNTGHA20BR
*4 PNKE1312Z2 (Black), PNKE1312Z1 (Silver)
Note:
R Please read the base unit’s operating instructions for additional/replacement
accessories.
– Optional headsets (KX-TGEA20): KX-TCA60, KX-TCA93, KX-TCA400,
KX-TCA430
Setting up
Connections/Wall mounting
Connect the AC adaptor to the power outlet.
Drive the screws ( ) (not supplied) into the wall, if necessary.
(
) 27.2 mm (11/16 inches)
1
2
1
2
For assistance, please visit http://www.panasonic.com/help
Installation
TGEA_TGHA20(en)_1004_ver001.pdf 2 2013/10/04 18:56:56
Note:
R Use only the supplied Panasonic AC adaptor PNLV233.
R The AC adaptor must remain connected at all times. (It is normal for the adaptor
to feel warm during use.)
R Make sure that the wall and the fixing method are strong enough to support the
weight of the unit.
Battery installation/Battery charging
Important:
R Use the supplied rechargeable batteries. For replacement, we recommend using
the Panasonic rechargeable batteries noted on page 2.
R USE ONLY rechargeable Ni-MH batteries AAA (R03) size (
1
).
R Do NOT use Alkaline/Manganese/Ni-Cd batteries.
R Confirm correct polarities (
, ).
Charge for about 7 hours.
R Confirm “Charging” is displayed (
2
).
R When the batteries are fully charged, “Fully charged” is displayed.
1
2
R Model shown is KX-TGEA20.
Note:
R If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends (
, ) and the charge contacts with a dry cloth and
charge again.
Registering a handset to a base unit
1 Base unit:
Press and hold MLOCATORN or MHANDSET LOCATORN for about 5 seconds.
R Depending on the base unit, a registration tone sounds.
For assistance, please visit http://www.panasonic.com/help
3
Installation
TGEA_TGHA20(en)_1004_ver001.pdf 3 2013/10/04 18:56:56
R If all registered handsets start ringing, press MLOCATORN or MHANDSET
LOCATORN again to stop, then repeat this step.
2 Handset:
Place the handset on the base unit or charger, then wait until a long beep
sounds and
is displayed.
Note:
R If an error tone sounds, or if
is displayed, register the handset according to
the base unit’s operating instructions.
Display language
1 MMENUN (right soft key) #110
2 MbN: Select the desired setting. a MSAVEN a MOFFN
For your safety
To prevent severe injury and loss of life/property, read this section carefully before
using the product to ensure proper and safe operation of your product.
WARNING
Power connection
R Completely insert the AC adaptor/power plug into the power outlet. Failure to do
so may cause electric shock and/or excessive heat resulting in a fire.
R Regularly remove any dust, etc. from the AC adaptor/power plug by pulling it
from the power outlet, then wiping with a dry cloth. Accumulated dust may cause
an insulation defect from moisture, etc. resulting in a fire.
R Unplug the product from power outlets if it emits smoke, an abnormal smell, or
makes an unusual noise. These conditions can cause fire or electric shock.
Confirm that smoke has stopped emitting and contact the Panasonic Call Center
at 1-800-211- PANA (1-800-211-7262).
Installation
R To prevent the risk of fire or electrical shock, do not expose the product to rain
or any type of moisture.
R Do not place or use this product near automatically controlled devices such as
automatic doors and fire alarms. Radio waves emitted from this product may
cause such devices to malfunction resulting in an accident.
4
For assistance, please visit http://www.panasonic.com/help
Installation
TGEA_TGHA20(en)_1004_ver001.pdf 4 2013/10/04 18:56:56
Loading...