Panasonic 96NKX TGDA20 Users Manual

Installation Manual

Additional Digital Cordless Handset

Model No. KX-TGDA20

Thank you for purchasing a Panasonic product.

This unit is an additional handset compatible with the following series of
Panasonic Digital Cordless Phone:
KX-TGC210/KX-TGC220/KX-TGD210/KX-TGD220/KX-WP110/KX-WP120
(The corresponding models are subject to change without notice.)
You must register this handset with your base unit before it can be used. This
installation manual describes only the steps needed to register and begin using
the

handset. Please read the base unit’s operating instructions for further details.

Please read this installation manual before using the unit and save it for future
reference.
For assistance, visit our Web site: http://www.panasonic.com/help
for customers in the U.S.A. or Puerto Rico.

Printed in China

PNQX6491ZA

PC1213MU0 (E)

TGDA20_(en_en)_1114_ver020.pdf 1 2013/11/14 15:24:43

Accessory information

Supplied accessories

Accessory item/Order number Quantity

Charger/PNLC1056ZN 1

Rechargeable batteries/HHR-4DPA 2

Handset cover

*

1

/PNYNTGDA20NR

1

Belt clip/PNKE1054Z4 1

*1 The handset cover comes attached to the handset.

N

ote:

R Please read the base unit’s operating instructions for additional/replacement

accessories.

Setting up

Connections/Wall mounting

Connect the AC adaptor to the power outlet.
Drive the screws 1 (not supplied) into the wall, if necessary.

2

27.2 mm (1 1/16 inches)

1

2

1

2

Note:

R T

he AC adaptor must remain connected at all times. (It is normal for the adaptor

to feel warm during use.)

R Make sure that the wall and the fixing method are strong enough to support the

weight of the unit.

2

For assistance, please visit http://www.panasonic.com/help

Installation

TGDA20_(en_en)_1114_ver020.pdf 2 2013/11/14 15:24:43

Battery installation/Battery charging

Important:

R Use the supplied rechargeable batteries. For replacement, we recommend using

the Panasonic rechargeable batteries noted on page 2.

R USE ONLY rechargeable Ni-MH batteries AAA (R03) size (1).
R D

o NOT use Alkaline/Manganese/Ni-Cd batteries.

R Confirm correct polarities (

, ).

Charge for about 7 hours.

R Confirm “Charging” is displayed (2).
R W

hen the batteries are fully charged, “Fully charged” is displayed.

1

2

Note:

R I

f the batteries are fully charged, but the operating time seems to be shorter,

clean the battery ends (

, ) and the charge contacts with a dry cloth and

c

harge again.

Registering a handset to a base unit
1 B

ase unit:

Press and hold MLOCATORN for about 5 seconds.
R If all registered handsets start ringing, press MLOCATORN again to stop,

then repeat this step.

2 Handset:

Place the handset on the base unit or charger, then wait until a long beep
sounds and

is displayed.

N

ote:

R If an error tone sounds, or if

is displayed, register the handset according to

t

he base unit’s operating instructions.

For assistance, please visit http://www.panasonic.com/help

3

Installation

TGDA20_(en_en)_1114_ver020.pdf 3 2013/11/14 15:24:43

Display language
1 MMENUN #110

2 MbN: Select the desired setting. a MSAVEN a MOFFN

For your safety

T

o prevent severe injury and loss of life/property, read this section carefully before

using the product to ensure proper and safe operation of your product.

WARNING

Power connection

R C

ompletely insert the AC adaptor/power plug into the power outlet. Failure to do

so may cause electric shock and/or excessive heat resulting in a fire.

R Regularly remove any dust, etc. from the AC adaptor/power plug by pulling it

from the power outlet, then wiping with a dry cloth. Accumulated dust may cause
an insulation defect from moisture, etc. resulting in a fire.

R Unplug the product from power outlets if it emits smoke, an abnormal smell, or

makes an unusual noise. These conditions can cause fire or electric shock.
Confirm that smoke has stopped emitting and contact us at http://
www.panasonic.com/contactinfo

Installation

R T

o prevent the risk of fire or electrical shock, do not expose the product to rain

or any type of moisture.

R Do not place or use this product near automatically controlled devices such as

automatic doors and fire alarms. Radio waves emitted from this product may
cause such devices to malfunction resulting in an accident.

CAUTION

Installation and location

R T

he AC adaptor is used as the main disconnect device. Ensure that the AC

outlet is installed near the product and is easily accessible.

Battery

R W

e recommend using the supplied batteries or additional/replacement batteries
noted on page 2 for replacement battery information. USE ONLY rechargeable
Ni-MH batteries AAA (R03) size.

R Do not mix old and new batteries.

4

For assistance, please visit http://www.panasonic.com/help

Installation

TGDA20_(en_en)_1114_ver020.pdf 4 2013/11/14 15:24:44