Pace 5050-0314 Service Manual

ASSEMBLY AND INSTALLATION INSTRUCTIONS

FOR PASTE DISPENSER CUBBY KIT

PACE PART NUMBER 6019-0038

MANUAL NUMBER 5050-0314 REV. A

The following instructions provide the user with the information necessary to assemble and install the PACE Paste Dispenser Cubby (P/N 6019-0314). Perform the following procedure step by step, in sequence, to obtain proper results:

1. Check the enclosed parts with the parts list (Table 1) to insure that you have all the required parts.

2. If 10cc or smaller barrels are to be used in the paste dispense operation, insert the bushing into the Hot Cubby Stand as shown. The Bushing will snap in place.

3. Attach the Hot Cubby Stand to the Base Stand as shown using one Mounting Screw and Hex Nut. Tighten Mounting screw to secure in place.

DESCRIPTION QUANITITY PART NUMBER

Hot Cubby Stand 1 1257-0126

Base Stand 1 1257-0173

Mounting Screw 2 1405-0398-02

Hex Nut 2 1410-0088 Bushing 1 1251-0076

Table 1. Parts List

Figure 1. Assembling Paste Dispenser Cubby

4. Attach the Paste Dispenser Cubby to the left side of the power source chassis using the procedure

below:

a) At the left rear of the power source, insert a Hex Nut into the top “T” slot on the left side of the

chassis. b) Insert a Mounting Screw through the mounting hole indicated on the Paste Dispenser Cubby. c) Place the Paste Dispenser Cubby in position on the left side of the power source. d) Attach Mounting Screw to Hex Nut (installed in T slot). e) Slide Paste Dispenser into position as desired. Tighten Mounting Screw to secure in place.

www.paceworldwide.com

Figure 2. Attaching Paste Dispenser Cubby To Power Source

PACE Incorporated retains the right to make changes to specifications contained herein at any time, withou notice. Contact your local authorized PACE Distributor or PACE Incorporated to obtain the lates specifications.

The following are trademarks and/or service marks of PACE, Incorporated, MD, USA:

INSTACAL POWERPORT TEKLINK™.

The following are registered trademarks and/or service marks of PACE Incorporated, Annapolis Junction Maryland U.S.A.

ARM-EVAC SODRTEK VISIFILTER

PACE products meet or exceed all applicable military and civilian EOS/ESD, temperature stability and othe specifications including MIL STD 2000, ANSI/JSTD 001, IPC7711, and IPC A-610.

™

, FUMEFLO™, HEATWISE™, PACEWORLDWIDE™, PERMAGROUND™,

™

, POWERMODULE™, TEMPWISE™, TIP-BRITE™, AUTO-OFF™, and

, FLO-D-SODR®, MINIWAVE®, PACE®, SENSATEMP®, SNAP-VAC®,

, SODR-X-TRACTOR®, ST 325®, THERMOJET®, THERMOTWEEZ®,

, THERMO-DRIVE®, and TOOLNET®.

dditional copies of this manual or other PACE literature may be obtained from:

PACE Incorporated

9030 Junction Drive

nnapolis Junction, MD 20701 Tel: (301) 490-9860 Fax: (301) 498-3252

www.paceworldwide.com

PACE Europe Limited

13 Tanners Drive Blakelands Milton Keynes Tel: (44) 1908-277666 Fax: (44) 1908-277777