Ozito BLV-2402 Instruction Manual
ELECTRIC
BLOWER VAC
2400W
INSTRUCTION MANUAL
SPECIFICATIONS
Voltage: 230-240V ~ 50Hz
Power: 2400W
No Load Speed: 14,000/min
Air Speed: 270 km/h
Mulching Ratio: 10:1
Collection Bag: 40L
Weight: 5.14kg
BLV-2402
WHAT’S IN THE BOX
Blower Vac
Blower Tubes
Collection Bag &
Shoulder Strap
Patio Extension
ozito.com.au
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
1 Place the lower tube onto
the upper tube.
1 Release the handle lock to
allow the secondary handle
to rotate.
3 Feed the top of the
assembled tubes into the
blower housing rst, then
squeeze the bottom to t.
2 Secure the tubes together
with two 16mm screws at the
top and one 24mm screw
and nut at the bottom.
Note: The nut will need to be
pushed into the recess
rmly to start the thread.
2 Rotate the handle to the
desired position and secure
in place with the handle lock.
4 Secure in place with the 2
remaining 24mm screws
and nuts.
1 Nose Guide Wheels
2 Lower Tube
3 Upper Tube
4 Secondary Handle
5 Shoulder Strap Hook
6 On/Off Switch
7 Collection Bag
8 Mode Selector Lever
9 Main Handle
BLOWER & VACUUM
ACCESSORIES:
KNOW YOUR PRODUCT
1 2 3 4 5 6
87 9
10 11
12
1. ASSEMBLY
SETUP & PREPARATION
Assembling the Tubes
Adjusting the Secondary Handle
10 Shoulder Strap
11 Assembly Screws x 5
(2 x 16mm & 3 x 24mm)
12 Patio Extension
WARNING: ENSURE THE TOOL IS TURNED OFF AND
DISCONNECTED FROM THE POWER SUPPLY BEFORE
PERFORMING ANY OF THE FOLLOWING OPERATIONS.
Note: To use the shoulder strap simply slide the strap over your
shoulder so that some of the weight of the blower vac can
be taken by your shoulder.
3 Connect the extension cord socket to the blower vac power
cord.
Attaching & Removing the Patio Extension
Attaching the Collection Bag
Shoulder Strap
Removing the Collection Bag
Extension Cord Retainer
Note: To avoid the extension cord from detaching; always
check that the cord is attached to the cord retainer before
use.
2 Place the loop onto the cord
retainer.
2 Pull the collection bag
away from the housing.
1 To attach the patio
extension push the head
into the lowwer tube so it
clicks into place.
2 To remove, push the
tabs on the side of the
extension out and then
slide the head out.
1 Attach the clip on the
collection bag to the hook
underneath the upper tube.
1 Make a loop with
the extension
cord and push
it through the
square hole under
the motor housing.
1 Pull down on the
tab at the back of
the collection bag
connector.
2 Attach the plastic
connector at
the top of the
collection bag to
the outlet in the
housing.
1 Ensure the shoulder strap
is clipped onto the top of
the blower.
2 To unclip the blower, press
either side of the buckle.
Loading...