Oricom TV7300 User Manual

TV7300

A

mplified Wireless Televisión

Listening Device

User Guide

Keep this user guide for future reference. Always retain your proof of

purchase in case of warranty service and reister your product on line at

www.oricom.com.au

Introduction

The Oricom Digital TV Listener is an amplification system specifically designed for
people with hearing difficulties.

It can be used with all kinds of Audio, Television systems, suitable for individuals
or groups without any interference.

Audio output from a TV or audio device is encoded and transmitted by the Base,
the wireless Headset receives the signal and decodes it to original audio sound.

One Base can be paired with up to 4 Headsets.

Safety & Care advice

To make the best use of this product and to use it safely, please read these
instructions thoroughly before use and keep safe for future reference.

Warning: This product can be very loud. Take care to prevent others from
using this product, if they do not have the same level of hearing loss. Excessive
sound pressure from earphones and headphones can cause hearing loss.

Caution: Electric shock. DO NOT insert unattached plug heads in to mains
power sockets. Plug heads MUST be fitted to the power adaptor.

Electrical connection: The unit is designed to operate from a 100-240VAC ­50/60Hz supply. (Classified as 'hazardous voltage' according to EN 60950
standard).

The unit does not incorporate an integral power on/off switch. To disconnect the
power, either switch off supply at the mains power socket or unplug the AC
adaptor. When installing the unit, ensure that the mains power socket is readily
accessible.

Caution: Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.

Keep the unit away from heat sources.
DO NOT expose the unit to direct sunlight.
Clean the Headset and ear pads regularly.
DO NOT modify the unit in any way.
Please note: The unit may be subject to interference from appliances that

generate strong electrical or magnetic fields e.g. microwaves, mobile phones,
lighting transformers etc.

1

Pack Contents

1. Headset 2. Alternative ear pads

3. Base 4. Power adaptor with cable
(1.5m) (AUS, UK, EU & US)

5. Slider tool 6. Batteries

7. 3.5mm to 3.5mm cable

8. 3.5mm to 6.3mm adaptor

(1.5m)

9. 3.5mm to 2 pin RCA cable

10. 2-pin RCA scart adaptor

(25cm)

11. Microphone

Table of Contents

Pack contents 2 Pairing extra headsets 11 -12
First use / Charging batteries 3 - 5 Cleaning & Maintenance 12
Connecting to TV, HiFi and other

Spare/replacement parts 13
audio equipment 6 - 8
Using Headset 8-10 Customer support 13
Headset adjustments 8-10 General information 13-14
Battery status & recharging 10-11

2

3

First use / Charging batteries

Important: The Oricom Digital TV Listener is supplied with two batteries.
Before use, batteries MUST be fully charged, full charge will take about 2-3 hours
when the battery is empty.

Caution: If battery is already fully charged, the red LED will stay off.
Once fully charged the TV Listener has an approximate operating time of up to 3

hours (per battery, with Headset on medium volume).
Batteries cannot be overcharged, but to save power the Base should be

disconnected from the power supply when not in use.

Battery Warnings:

 DO NOT attempt to dismantle.
 DO NOT dispose of in fire.
 DO NOT swallow.
 Keep away from children.
 Batteries are to be inserted with the correct polarity.
 DO NOT short-circuit the supply terminals.
 Exhausted batteries are to be removed from the product.
 Only use Oricom supplied 'Li-Po' batteries.
 Caution: Risk of explosion if battery is replaced incorrectly or

fitted with the wrong type of battery. Dispose of used batteries
according to the instructions.

Connect Multi-input adaptor

Select the Australian power plug and
connect to the socket on the ac
adaptor.

Insert power adaptor into mains power
socket. Insert power jack (7) into ‘DC
IN 5V’ socket on the back of the Base.

4

5

Insert batteries (6) into Headset and
Base.
Place Headset in Base.

Caution: Please be sure to insert the
battery correctly (see above).

Turn power on at mains and Base.
Red lights will show on Base and

Headset to indicate batteries are
charging.

After 2-3 hours, when fully charged the
red lights will be off.