Orange Two Stroke Owner’s Manual

USER MANUAL

ORANGE AMPS

LONDON • ENGLAND

VOICE OF THE WORLD

™

EST. 1968

IN USE

Experiment with the position of the Two Stroke in
your signal chain (e.g. before/after other pedals, in
front of your amplifier or in the effects loop). There
are no rules with this pedal!

When the HI or LO controls are set to 12 o’clock
(unity gain), the corresponding FREQ control will
have no effect. Set both HI and LO to 12 o’clock for
a transparent clean boost where no additional EQ
is required.

POWER

9V Battery Operation

The battery installed at the factory is for testing
purposes. If you notice a drop in performance,
replace the battery. To replace the battery,
unfasten the four screws on the base and secure
the new battery in the battery clip, making sure to
observe the battery’s polarity (+ / -). When
powering the pedal from a 9V battery, disconnect
the input when not in use to prolong battery life.

DC Adaptor

The Two Stroke can be powered by 9 or 12V DC.
Use a regulated AC-DC adaptor fitted with a centre
negative plug (2.1mm). Running at 12V will increase
the headroom and the output volume available.

A

FREQ

Selects the HI frequency

(850Hz – 8.5kHz)

B

HI

Controls the boost/cut of the HI

frequency (+/- 18dB).

12 o’clock position = unity gain

C

FREQ

Selects the LO frequency

(120Hz – 1.2kHz)

D

LO

Controls the boost/cut of the LO

frequency (+/- 18dB).

12 o’clock position = unity gain

E

OIL

Controls the level of clean volume

boost before the EQ

Set to minimum = Unity gain

1

INPUT

Connecting a jack plug to the input

switches on the power to the pedal

2

OUTPUT

All Orange pedals feature a highly

transparent, low impedance

buffered bypass output

3

BYPASS

SWITCH

LED will illuminate when the pedal

is engaged

4

9-12V DC

INPUT

Use only a DC adapter with a centre

negative plug

Specifications

Current draw: 20mA @ 9V

(W) 95 x (H) 65 x (D) 130mm / 462g exc. batt.

1

3

2

4

D

A

C

E