OPTI-UPS PS500C User Manual

INREMOTE

PORT

INPUT

SURGE PROTECTED OUTLET

BATTERY BACKUP OUTLETS

OUT

INREMOTE

PORT

OUT

INPUT

CURCUIT
BREAKER

CONVENIENCE OUTLET

BATTERY BACKUP OUTLETS

INREMOTE

PORT

INPUT

SURGE PROTECTED OUTLET

BATTERY BACKUP OUTLETS

OUT

Series

Standby UPS

PS500C / PS700C

Features

* Pure Sine wave
* Line-interactive design
* Boost and buck AVR
* Overload, AVR, on-line, back up and battery status LEDs display
* Fully digitized microprocessor control
* RS-232 or USB communication port (500VA~700VA models)
* RS-232 and USB communication port (1000VA~3000VA models)

SpecificationsFront Panel

PS500C / PS700C

Rear Panel

PS500C / 700C

110V / 120V

Line Normal
Backup

Boost AVR
Buck AVR
Fault

On / Test

Off

USB
RJ11 / RJ45

Circuit Breaker

Suge Protected Outlets

Battery Backup Outlets

Input

USB
RJ11 / RJ45

Surge Protected
Outlets
Battery Backup Outlets

Typology
On-battery Output Wave Form

INPUT

Capacity
Voltage
Frequency

OUTPUT

Voltage (on battery)
Frequency (on battery)
Voltage Regulation AVR

PROTECTION AND FILTERING

Spike Protection
Unit Input
EMI/RFI filter
Overload protection

Transfer Time
Short Circuit

BATTERY

Type
Typical Recharge Time
User Replaceable Battery
Protection

Back-up Time

ALARM

Battery Back-Up
Battery Low
Overload

INTERFACE

RS-232 or USB Interface

ENVIRONMENT

Operation

Audible noise
Storage condition

PHYSICAL

Net Weight Kg(Net/Gross)

Dimension (Physical/ Packing)
(L x W x H)

* See VS1000C on page 6

(lbs)

(kg)

(in)

(mm)

* PS500C / PS700C

* Lightning and surge protection
* Short circuit and overload protection
* 50/60Hz frequency auto sensing
* Tel / modem / internet spike protection
* Cold start (DC power on)
* Hot swappable battery
* SNMP card slot (PS1000C-PS3000C)

PS500C

Line-Interactive
Pure Sine Wave

500VA/300W 700VA/420W

100V, 110V, 115V, 120V / 220V, 230V, 240V*

50 or 60Hz +/-10% (auto sensing)

Pure sine wave output at nominal +/-5%

AVR automatically increases output voltage 15% above input voltage when input voltage

drops lower than 9% from nominal. AVR decreases output voltage 13% below input voltage

when input voltage rises higher than 9% from nominal.

Fuse or Circuit breaker for overload & short circuit protection

UPS automatic shutdown if overload exceeds 110%

of nominal for 20 seconds and 125% for 2 seconds

UPS output cut off immediately or input open protection

12V / 7AH x 1

Automatic self-test & deep discharge protection,

10 - 30 minutes (depending on computer load)

Slow beeping sound (about 0.25Hz)

Rapid beeping sound (about 1.00Hz)

Elevation: 3,500m max, Humidity: 0%-95%(without
condensation formation), Temperature: 0-40 deg C

14.5 / 16.3 15.6 / 17.4

6.6 / 7.4 6.7 / 7.9

50 or 60Hz +/-0.5%

320 Joules, 2ms

10dB at 0.15MHz, 50dB at 30MHz

Sealed, maintenance free lead-acid

Battery test, UPS ON/OFF Schedule,
AC input/output power status display

2~4 milliseconds (typical)

4 hours (to 90% of full capacity)

Replace battery indicator

Continuous beeping sound

<40dBA (1 meter from surface)
15000 meters max. elevation

12.6 x 3.8 x 5.3 / 16 x 7.6 x 10.2
320 x 97 x 135 / 406 x 192 x 258

PS700C

12V / 34W x 1

UPS Series

Line Interactive

Series

On Line UPS

AVR Series

Inverter Series

Surge Series

Series

Green Power

220V / 230V / 240V

Input
Fuse

windows

2000 / XP

2003 / Vista

25.

Sine Wave

Series

Networking