The OPR 3101 scanner uses Bluetooth technology
for wireless transmission of scanned barcode data.
Specifications Manual
All information subject to change without notice.
Document History
Opticon
OPR 3101
Specifications Manual
Model Number:
Edition:
Date:
OPR 3101
1A
2009-08-31
Specification Number:
Original Spec Number:
SS07028
SS07012
Copyright 2007 Opticon. All rights reserved.
This manual may not, in whole or in part, be copied, photocopied, reproduced, translated or converted to any electronic or
machine readable form without prior written consent of Opticon.
Limited Warranty and Disclaimers
PLEASE READ THIS MANUAL CAREFULLY BEFORE INSTALLING OR USING THE
PRODUCT.
Serial Number
A serial number appears on all Opticon products. This official registration number is directly related to the device
purchased. Do not remove the serial number from your Opticon device. Removing the serial number voids the warranty.
Warranty
Unless otherwise agreed in a written contract, all Opticon products are warranted against defects in materials and
workmanship for two years after purchase. Opticon will repair or, at its option, replace products that are defective in
materials or workmanship with proper use during the warranty period. Opticon is not liable for damages caused by
modifications made by a customer. In such cases, standard repair charges will apply. If a product is returned under
warranty and no defect is found, standard repair charges will apply. Opticon assumes no liability for any direct, indirect,
consequential or incidental damages arising out of use or inability to use both the hardware and software, even if Opticon
has been informed about the possibility of such damages.
Packaging
The packing materials are recyclable. We recommend that you save all packing material to use should you need to
transport your scanner or send it for service. Damage caused by improper packaging during shipment is not covered by
the warranty.
Trademarks
Trademarks used are the property of their respective owners.
Opticon Inc. and Opticon Sensors Europe B.V. are wholly owned subsidiaries of OPTOELECTRONICS Co., Ltd., 12-17,
Tsukagoshi 4-chome, Warabi-shi, Saitama, Japan 335-0002. TEL +81-(0) 48-446-1183; FAX +81-(0) 48-446-1184
This manual provides specifications for the OPR 3101 gun-type wireless laser barcode
scanner.
2. Overview
The OPR 3101 scanner uses Bluetooth technology for wireless transmission of scanned
barcode data. Main features of the OPR 3101 are:
•Laser beam scanning: The use of a short-wavelength red laser beam enhances the
visibility of scanning lines.
•Customized ASIC for decoding: Utilization of high-speed ASIC increases data
processing speed and improves reading performance of low-quality printed barcodes.
•Rugged housing for heavy-duty applications: The OPR 3101 is enclosed in a
rugged housing sealed to IP-54 standards that withstands repeated drops of up to
two meters onto concrete. This scanner is suitable for use not only in offices or shops
but also in warehouses.
Opticon
OPR 3101
Specifications Manual
•Bluetooth technology for wireless communication: The OPR 3101 supports
Bluetooth with Class 2 output power. It enables data communication at distances up
to 10 meters.
•Rechargeable in the designated cradles: It takes only about 5 hours to fully
recharge the OPR 3101 in the designated cradle CHG-3101 or CRD-3101. The CHG3101 recharges the scanner while the CRD-3101 offers both recharging and
communication features. (It takes about 10 hours to recharge the battery using USB
bus power.)
• The OPR 3101 complies with RoHS
6
Supported symbologies:
Linear (1D) Postal 2D
JAN/UPC/EAN, incl. add-on Chinese Post Composite codes
Codabar/NW-7 Korean Postal
Code 11 PDF417
Code 39
Code 93
Code 128
GS1-128 (EAN-128)
GS1 Databar (RSS)
IATA
Industrial 2of5
Interleaved 2of5
ISBN-ISMN-ISSN
Matrix 2of5
MSI/Plessey
S-Code
Telepen
Tri-Optic
UK/Plessey
Opticon
OPR 3101
Specifications Manual
MicroPDF417
Authority Code
3. Physical Features
3.1. Dimensions
W 68.0 x D 155.0 x H 165.0 mm
3.2. Weight
250 g (excludes the weight of a 40-gram battery pack).
7
4. Environmental Specifications
4.1. Operating Temperature and Humidity
Temperature: -10 to 60° C
Humidity: 5 to 95%
4.2. Charging Temperature
Temperature: 0 to 40° C
Note: Battery charging may stop when the scanner is charged at a temperature higher
than 40° C
4.3. Storage Temperature and Humidity
Temperature: -20 to 60° C
Humidity: 5 to 95%
Opticon
OPR 3101
Specifications Manual
8
4.4. Ambient Light Immunity
Decoding performance is guaranteed when the range of illumination on a barcode
surface is between zero and the following values:
Incandescent light 4,000 lx
Fluorescent light 4,000 lx
Sunlight 80,000 lx
Conditions
Barcode Sample: OPTOELECTRONICS Test Sample
PCS: 0.9
Resolution: 0.25 mm
Symbology: 9-digit Code 39
Quiet zone: 10 mm
N/W ratio: 1:2.5
Distance: 150 mm
Angle (see note below): α = 0° β = 15° γ = 0°
Curvature: R = ∞
Power supply voltage: 3.7 V
Opticon
OPR 3101
Specifications Manual
Direct light or specular reflection from a light source should be prevented from entering
the acceptance area.
Note: α, β and γ respectively represent pitch, skew and tilt. Please see section 7 for how
these values are defined.
Figure 1: Ambient light immunity
9
5. Electrical Specifications
5.1. Configuration
The OPR 3101 consists of three subsections: a laser scan engine, which converts
scanned data into analog signals and outputs the data; a decoding and communication
section, which decodes the data and controls the system; and a power supply and
interface section.
Figure 2: Configuration of OPR 3101.
Opticon
OPR 3101
Specifications Manual
5.2. Main Battery
The main battery is a lithium-ion secondary battery.
Nominal capacity: 1620 mAh
Nominal voltage: 3.7 V (When discharging 0.2 CA.)
5.3. Current Consumption
Parameter Specifications Notes
Idle 1 30 mA (typ.) Without connection to communication line.
Idle 2 35 mA (typ.) With connection to communication line.
In use (Average) 165 mA When scanning, communicating, or lighting LEDs.
Maximum consumption 220 mA Maximum consumption in operating state.
10
5.4. Charging Current
Parameter Specification Note
Opticon
OPR 3101
Specifications Manual
CRD-3101 while charging
Testing Conditions Operating temperature: 25° C
Note: Model names of AC adaptors dedicated to CHG-3101 and CRD-3101.
- Model for OSE and OPTICON: GP-ACGN13T-K4-2
- Model for Japan and North American Market: GP-ACGN13U-K4-2
500 mA or lower When connected to RS-232C (when using AC adaptor)
Output: 6 V, 750 mA
200 mA or lower When connected to USB, use high power port (500
mA).
Charging Temperature: 0 to 40° C
Battery charging operation may be stopped when the scanner is charged at
the temperature higher than 40° C.
Battery charging operation may be stopped when the power supply voltage
impressed to the charging terminals exceeds the range of 3 to 6 V.
5.5. Battery Operating Time and Charging Time
Parameter Specification Note
Idle 1 About 55 hours Without connection to communication line.
Battery Life
Charging Time
Idle 2 About 48 hours With connection to communication line.
In use About 25 hours
Charging
time 1
Charging
time 2
About 5 hours
About 10 hours
Without connection to communication line and
scanning once in every 5 seconds.
When using CHG-3101 or CRD-3101 and connected
to RS-232C.
When using CRD-3101 and connected to USB (bus
power supply).
Note: Battery life may be shorter than specified above when the quality of the battery
pack is degraded.
11
Loading...
+ 24 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.