Page 1
OPL 2724 ZAPPER - QUICK START
(Slave mode)
After configuring the Bluetooth communication parameters using the
Wireless Reader Configuration Instructions, scan through steps 1-8 (as
appropriate) to complete the setup of your device
1.
2. _ENAU_ ENABLE AUTO CONNECT
OPTIONAL
3. _PC05_ ENABLE TRIGGER CONNECT (5 SECS)
4.
5.
6.
(Scanner will attempt to reconnect for 5 minutes)
Only if step 2 selected
7. _bbd_ TRIGGER TO MAKE CONNECTABLE
_ZZ_ SET
(Places scanner in set mode)
(Allows scanner to reconnect when returning in to range)
(Press and hold trigger for 5 seconds for a manual connection)
_PD08_ ENABLE TRIGGER DISCONNECT (8 SECS)
(Press and hold for 8 seconds for manual disconnection)
_AD01_ POWER SAVE MODE
(Scanner will disconnect if idle for 10 minutes)
_CA05_ AUTO RECONNECT (5 MINS)
8.
_ZZ_ END
_+-DSCO-+_ SCAN TO MAKE DEVICE DISCOVERABLE
Page 2
Loading...