Oppo RMK-105 User Manual

®

Rack Mount Kit Installation Guide

Part Number: RMK-105

Contents: (2) rack mount brackets, (2) rack mount spacers, and (4) side panel screws.

Installation:

1. Remove the 4 screws from the BDP-105’s left
and right panels. Save the screws for Step 3.

2. Position the Right bracket (marked with “R”)
to the right side of the player, as shown in
Figure (1). Secure the bracket to the player
using the side panel screws supplied with the
rack mount kit. Do not use the side panel

Figure 1

screws removed from the player because
those are too short. Install the Left bracket
similarly.

3. Position the shorter spacer over the top of the
front panel of the player, as shown in Figure
(2). Use two screws saved from Step 1 to
secure the spacer at each end to the Left/Right
brackets. Install the taller spacer under the
front panel similarly.

4.

The completed unit should look like Figure
(3). It is ready to be mounted using the screws
that came with your equipment rack.

Caution:

The player needs to fit into a 3U rack space. It
is recommended to leave a blank or ventilated
1U space below and above the player to allow
for better cooling.

The player should not be installed directly
above a heat-generating device such as a power
amplifier or A/V receiver.

Please also check the rack manufacturer’s
instructions and allow for enough ventilation
(Bottom, Top and Sides).

Figure 2

Figure 3

OPPO BD UK Ltd

42 Hellesdon Park Road

Norwich, NR6 5DR, UK.

0845 060 9395 – [e-mail]