Omnimount PMD2, PMD1, PMD.5 User Manual

Installation Instructions

PMD.5 — PMD1— PMD2:
Universal Projector Mounts

Thank you for purchasing an OmniMount product.

Specifications are subject to change without prior notice.

Every effort has been made to provide accurate and error-free assembly and installation.
OmniMount Systems disclaims liability for any difficulties arising from the interpretation
of information contained in these instructions. If OmniMount products are used for pur­poses other than their original intent, OmniMount, its distributors and retailers shall not
be held responsible or liable for injuries or property damage, direct, indirect, or conse­quential, which may arise from the inability to use this product safely, properly, and in the
manner for which it has been designed and manufactured. Warranty does not apply to
products which have been lost, damaged by misuse, abuse, or accident.

OmniMount Systems, Inc.

8201 South 48th Street • Phoenix, AZ 85044-5355

1-800-MOUNT-IT • www.omnimount.com

P/N 1002082—Rev. D 9/2004

8

Universal Mounting Grid
Superior Mounting Flexibility
Adjustable Ceiling Pipe Drop

IMPORTANT: To utilize the PMD projector mount, the projector must have

mounting lands (threaded inserts) on the base. Contact OmniMount if you have any
questions regarding the proper installation of this projector mount system.

Questions? 1-800-MOUNT IT

Models: PMD.5 — PMD1 — PMD2

Step 5

Slide the bottom projector mounting plate onto
the previously installed top projector mounting
plate. (Fig. 11)

Note: Make sure that the cables don’t get
pinched while sliding the plates together.

Fig. 11

Fig. 12

Important: Always secure projector plates by installing 3/8”
screws (G) into holes on front edge of plates.

Additional security can be provided by installing small pad­locks through security slots at the rear of the projector plates.
(Fig. 12)

Attach cables to the projector. Turn projector ON, and make pitch
and keystone adjustments as per the projector manufacturers
instructions. For additional pitch/tilt, use the three adjustment
knobs on top of the PMD mount (Fig. 13).

Fig. 13

2

Part Description Qty.

Mount Assembly Hard-

ware

A Top Projector Plate 1
B Bottom Projector Plate 1
C Pipe Drop Assembly 1
D Plastic Cover 1

E Ceiling Plate 1 Bag
F Hex Screw: ¼”-20 X ¼” 1 (d)

G Screw: ¼”-20 X 3/8” 2 (c)
H Hex Screw: ¼”-X 5/8” 4 (d)

I Hex Screw: ¼”-X ½” 6 (d)
J Lag Bolt: 5/16” X 3” 4 (e)
K Plastic Plugs 14 (b)

Hex Wrench 1 (d)

7