OK-I SDMIVD35-55AIDN, SDMIVD35-55AIDNP, SDVD-55AIDNP, SDVD-55AIDN Operational Manual

Please read the Operational Manual
before attempting to use this product.

Super Low Lux DNR Vandal Proof Dome Camera

Operational Manual

Digital Noise Reduction

Mechanical IR

Cut Filter

Removable (ICR)

This color video camera employs a 1/3 inch CCD solid-state imaging device with 470/410K picture elements. This unit is equipped
with a newly developed DNR DSP
technology which suppresses all significant noise while AGC is activated. So the camera is able to deliver a smooth and more
even picture that has enhanced readability and saves video storage space.

The Digital Noise Reduction technology is built into the camera to eliminate any noise associated with low light environment.
Ghost and blooming effects are reduced dramatically, leaving the image clean and vivid. An added benefit is that the HDD
required for DVR recording is substantially reduced by up to 70%, due to the DNR technology. Sturdy and IP66 enclosure
ensures the camera to stay in its best condition even under the most critical environments.

For using 12V DC power adaptor, please use 1000mA for each SDMIV35 and 500mA for each SDVD.
UL with Regulator.

FEATURES

SDMIVD35-55AIDN/SDMIVD35-55AIDNP

z 1/3” Sony Super HAD CCD
z 550 TV Lines
z 35 IR LED
z IR Distance 65~80ft / 20~25m
z 3.0mm~12.0mm Auto Iris Lens / F1.4

Lens Made in Japan (Tamron)

z Advanced Digital Noise Reduction (DNR)
z Mechanical IR Cut Filter Removable (ICR)
z IR Accuracy: Vivid color performance in the daytime and

sharp B/W image with no focus shift in the nighttime

z IP66 Rating, Heavy-duty, weather & vandal proof
z Built-in horizontal/vertical adjusting mechanism for multi-

dimensional adjustment

z Advanced wide range Auto Tracing White Balance (ATW),

automatically adjusts the white balance according to the
color temperature in the environment

z Smart digital control Auto Back Light Compensation (BLC)
z Outstanding Signal to Noise Ratio Better than 50dB
z Special Distortion-free Acrylic Vandal Dome Cover
z Dual Power 12V DC / 24V AC Auto Select

P = PAL Version

35 IR Day & Night ICR 550 TVL
SDMIVD35-55AIDN
SDMIVD35-55AIDNP

(Digital Signal Processor) for video processing. The DNR function is a newly developed

Hi-Res. 550 TVL
SDVD-55AIDN
SDVD-55AIDNP

SDVD-55AIDN/SDVD-55AIDNP

z 1/3” Sony Super HAD CCD
z 550 TV Lines
z 3.0mm~12.0mm Auto Iris Lens / F1.4

Lens Made in Japan (Tamron)

z Advanced Digital Noise Reduction (DNR)
z IP66 Rating, Heavy-duty, weather & vandal proof
z Built-in horizontal/vertical adjusting mechanism for

multi-dimensional adjustment

z Advanced wide range Auto Tracing White Balance

(ATW), automatically adjusts the white balance
according to the color temperature in the
environment

z Smart digital control Auto Back Light Compensation

(BLC)

z Outstanding Signal to Noise Ratio Better than 50dB
z Special Distortion-free Acrylic Vandal Dome Cover
z Dual Power 12V DC / 24V AC Auto Select

SDMIVD35-55AIDN_ SDVD-55AIDN_rev09192008 1

PARTS AND FUNCTIONS

A. Camera

B. Bracket

C. Bottom Housing

D. Vari-Focal Lens

E. Safety String

F. Upper Housing

G. Screw Hole

H. Cable Hole

I. LED Board

J. Control Board

I. Power Source: 12V DC / 24V AC (Non-polarity) Block Terminal

II. Video Out

III. DC Auto Iris Level Adjustment - Adjusting DC drive auto

iris lens driving level for obtaining correct exposure light

IV. RCA Video Out

 Factory Default

SDMIVD35-55AIDN_ SDVD-55AIDN_rev09192008 2

INSTALLATION

Step 1: Camera Cabling

A. Decide how the camera will be mounted.
B. Decide how the cable will be connected to the camera.

a. Using ½” pipe from the side
b. Using the cable hold at the base of the camera with or without pipe

C. Be sure to use proper waterproofing process regardless of what method you use to connect the cable.

NOTE: Warranty will be VOIDED if camera is damaged by water or moisture due to improper installation without waterproofing.

Step 2: Removing Dome Cover

Remove dome cover from the main body by loosening the four dome cover mounting
screws. The dome cover is fixed with tamperproof screws. Loosen the four dome cover
mounting screws by using the supplied bit for tamperproof screws.

Step 3: Securing Camera

Place mounting plate at position which the camera will be mounted and fix the screw holder and then screw 4x 26mm screws x4.

Step 4: Focus & Angle Adjustment

We have provided a service monitor RCA connection jack for your convenience.

SDMIVD35-55AIDN_ SDVD-55AIDN_rev09192008 3