Oki D508 ACCESSORY INSTRUCTION GUIDE

Setup

1

4

2

1

2

3

or

5 6 7

98

Error No. Problem Remedy

0 Flash memory overflowing Contact the place where you bought the printer.
2 PCB hardware failure Contact the place where you bought the printer.
3 EEPROM failure Contact the place where you bought the printer.
4 Physical damage on the

printhead
5 Loose printhead Close the top cover until it firmly latches.
6 Running out of media Load a new roll of labels.
7 Incorrect sensor selection or

sensitivity setting
8 Cutter disconnected or cutter

failure while in cutter mode

8. Flash ROM read error Contact the place where you bought the printer.
A Data overflowing Press the power button to turn off the printer.

B, C, D Wrong setting of data

transmission between the

computer and the printer.

(This error is applicable only

when RS-232C I/F is used.)

Contact the place where you bought the printer.

Contact the place where you bought the printer.

Contact the place where you bought the printer.

Press the power button again to turn on the
printer. Reprint the labels.

Check the data transmission settings, or contact
the place where you bought the printer for
appropriate settings such as baud-rate, parity,
and Data/Stop bit.

PN: 9001181 @ 2008 Sato America, Inc. All rights reserved.