OFNA Racing PCR Laydown Servos User Manual

LAYDOWN SERVO CONVERSION KIT
PART# 19790

PCR RADIO

1

TRAY

3x8mm

PCR RADIO

2

TRAY

3x10mm SCREWS

3

1

1

7
1

1

1

LOCKTIGHT

3x8mm

3x10mm

PCR RADIO

4

Note: Depending on servo brand, edge
on servo mounts may need to be trimmed
to allow steering servo to mount flush.

TRAY

Note: Steering servo may
need to be adjusted with
4mm spacers accordingly,
depending on servo brand.

PCR RADIO

5

3mm Hex Ball

TRAY

3x12mm

3x14mm

5x8mm

Linkage

1

Tie-Rod

1

Tie-rod

2

3mm

3

3x5mm

3

2

3

1

1

1

1

2

5x8mm
Bearing

LOCKTIGHT

3x12mm

3x12mm

3x5mm

3

3

LOCKTIGHT

Note: Apply a small amount
of locktight on each 3mm Hex Ball.

61.0mm

3x14mm

37.5mm

3x12mm

Note: Servo
horns are for
futaba servo's
only. For other
servo's use
existing servo
horns, or use
Part #10767

PCR RADIO

3

TRAY

3x10mm SCREWS

Note: Do not use metal grommet
inserts when mounting servo's.
4mm spacers may not be needed
depending on servo brand.

See Fig.4 for steering servo position.

8
4

4mm Spacers

3x10mm

3x10mm

PCR RADIO

6

TRAY

3x3mm

Spring

3

3

1

3x3mm

Spring

Note: Route servo leads appropriately,
so they will not come in contact with
the spur gear.