Nvidia GeForce FX, GeForce MX User Manual

GeForce FX/MX Series

VGA Card

User's Guide

Declaration of Conformity

According to 47 CFR, Parts 2 and 15 of the FCC Rules

The following designated product:

EQUIPMENT: VGA Card

is a Class B digital device that complies with 47 CFR Parts 2 and 15 of the FCC Rules. Operation
is subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may cause
undesired operation.

Disclaimer

The information in this document is subject to change without notice and does not represent a
commitment on the part of the vendor. No warranty or representation, either expressed or implied, is
made with respect to the quality, accuracy or fitness for any particular purpose of this document. The
manufacturer reserves the right to make changes to the content of this document and/or the products
associated with it at any time without obligation to notify any person or organization of such changes.
In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages arising out of the use or inability to use this product or documentation, even if advised of the
possibility of such damages. This document contains materials protected by copyright. All rights are
reserved. No part of this manual may be reproduced or transmitted in an y form, by any means or for
any purpose without express written consent. Product names appearing in this document are
mentioned for identification purposes only. All trademarks, product names or brand names appearing in
this document are registered property of their respective owners

.

Printed in Taiwan

FCC Compliance Statement

This equipment has been tested and found to comply with limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in residential installations. This equipment generates, uses, and can radiate radio frequency
energy, and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause interference to radio or television equipment
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Move the equipment away from the receiver.

- Plug the equipment into an outlet on a circuit different from that to which the

receiver is connected.

- Consult the dealer or an experienced radio/television technician for additional

suggestions.

Only equipment certified to comply with Class B should be attached to this equipment, and must have
shielded interface cables. You are cautioned that any change or modifications to the equipment not
expressly approved by the party responsible for compliance could void your authority to operate such
equipment. This device complies with Part 15 of the FCC rule. Operation is subjected to the following
two conditions:

1) This device may not cause harmful interference.

2) This device must accept any interference received, including interference that may cause

undesired operation.

Oct 2003

OST-CONSUMER

RECYCLED PAPER

100%

CONTENTS

Chapter 1 Introduction ..............................................................1

Product Specifications...........................................................................................1

Package Contents ..................................................................................................2

System Requirements............................................................................................2

Chapter 2 Hardware Setup........................................................3

Installing the Hardware........................................................................................3

硬體的安裝.............................................................................................................3

Installation du matériel.........................................................................................3

하드웨어 설치 .......................................................................................................4

Installation der Hardware....................................................................................4

Chapter 3 Driver Setup.............................................................. 5

Display Drivers Setup ...........................................................................................5

Display properties .................................................................................................5

Appendix....................................................................................6

WinCinema (Optional) .........................................................................................6

DirectX 9.0 (FX Series Only)................................................................................6

Video in Drivers (Optional)..................................................................................6

3Deep E-color (Optional)......................................................................................6

WinProducer3 (Optional).....................................................................................6