Nu-Vu SB-1 Installation Manual

MODEL# SB-1

CROWN VE RIT Y S I D E B U R N E R

OPERATING AND INSTALLATION INSTRUCTIONS

REV. 01 / 02

RETAIN FOR FUTURE REFERENCE

PLEASE R EAD TH E M C B OWN E R'S MAN UAL, REFERENCES ARE MADE TO

IT. OBEY ALL SAFETY WARNI N GS AN D P ROCEDURES.

Photo

Thank you for purchasing this quality product.

With proper use the SB-1 side burner will enhance the

outdoor cooking experience for many years.

Crown Verity inc. is proud of this product.

We hope you will enjoy using it.

This appliance is for operation outdoors only

ANSI Z83.11A / CGA 1.8 - M 97

FOR YOU R SAF ETY

Do not store or use gasoline or other
flammable vapors or liquids in the
vicinity of this or any other appliance.

WARNING: Improper installation,
adjustment, alteration, service or
maintenance can cause property
damage, injury or death. Read the
installation, operating & maintenance
instructions thoroughly before installing
or servicing this equipment.

Installation

The SB-1 side burner is offered in both mobile and built-in versions.
The mobile unit, which attaches to the right side of all MCB charbroilers, is offered
in L.P (propane) gas only. The built in version SB-1-BI is offered in both L.P. and Nat.
gas. Installation must conform with local codes.

SB-1 (mobile) Installation

1. Remove the push handle from the right side of the grill by removing the two bolts
from the inside of the grill as shown in fig.1. You must remove the grids and the
front heat shield to access the front bolt.

2. Attach the side burner cabinet assembly to the grill using the nuts, bolts, and
washers supplied as shown in fig.2.

3. Remove the regulator assembly from the end of the hose as shown in fig. 3. On
larger units, choose the hose that is on the right (closest) side.

4. Install the brass "Tee" between the outlet of the regulator and the inlet of the hose
as shown in fig. 4. Be sure to tighten the threads enough to prevent any gas leaks.
Do not over-tighten the fitting into the regulator as it may crack
the regulator casing.

5. Attach the side burner hose with the use of two wrenches as shown in fig. 5.

6. Make sure the hoses do not come into contact with any hot surfaces, and are
routed outside of the rear leg(s). Adjust the orientation of the "Tee" and the
regulator as necessary. See fig.6.

7. Install the grate and protective cover.

8. Finally, before operating the side burner, perform a leak check by brushing
on a soap and water solution at every joint and watch for growing bubbles that
indicate a leak. Once you are confident there are no leaks, you may
operate your new Crown Verity side burner.

FIG.2

FIG.3

FIG.5

FROM SIDE
BURNER

FIG.1

FIG.4

FIG.6