NuTone IM-3303 Instruction Manual

VOLUME
SCAN
PM
1:00
PROGRAM OFF MEMORY 1
MEMORY 2
FM
MEMORY 3
CD/TAPE
MEMORY 4
AUX
MEMORY 5
TIMER
MEMORY 6
INSIDE/PATIO
END CALL
DOOR TALK
MASTER
NuTone
®
RADIO
INTERCOM SYSTEM
MODEL IM-3303 SERIES
HOMEOWNER'S
OPERATING
INSTRUCTIONS
Product specifications subject to change without notice.
Printed in China, Rev. 05/02, Part No. 83069
Two Year Limited Warranty
WARRANTY OWNER: NuTone warrants to the original consumer purchaser of its products that such products will be free from defects in materials or workmanship for a period of two (2)) years from the date of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR
IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
During this two year period, NuTone will, at its option, repair or replace, without charge, any
product or part which is found to be defective under normal use and service. THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS OR TUBES. This warranty does not cover (a) normal maintenance and service or (b) any products or parts which have been subject to misuse, negligence, accident, improper maintenance or repair (other than by NuTone), faulty installation or installation contrary to recommended installation instructions.
The duration of any implied warranty is limited to the two year period as specified for the express warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above limitation may not apply to you.
NUTONE’S OBLIGATION TO REPAIR OR REPLACE, AT NUTONE’S OPTION, SHALL BE THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY. NUTONE SHALL NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. Some states do not allow
the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. This warranty supersedes all prior warranties.
WARRANTY SERVICE: To qualify for warranty service, you must (a) notify NuTone at the address stated below or telephone 1/800-543-8687, (b) give the model number and part identification and (c) describe the nature of any defect in the product or part. At the time of requesting warranty service, you must present evidence of the original purchase date.
Date of Installation Builder or Installer
Model No. and Product Description
IF YOU NEED ASSISTANCE OR SERVICE:
For the location of your nearest NuTone Independent Authorized Service Center:
Residents of the contiguous United States Dial Free 1-800-543-8687
Please be prepared to provide:
Product model number • Date and Proof of purchase • The nature of the difficulty Residents of Alaska or Hawaii should write to: NuTone Inc. Attn: Department of National Field Service, 4820 Red Bank Road, Cincinnati Ohio 45227-1599. Residents of Canada should write to: Broan-NuTone Canada, 1140 Tristar Drive, Mississauga, Ontario, Canada L5T 1H9.
Rev. 03/2001
2
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: — Reorient or relocate the receiving antenna. — Increase the separation between the equipment and receiver. — Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
FCC Warning – This equipment may generate or use radio frequency energy. Changes or modification to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.
FCC Warning – Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
The serial number of this product may be found on the back of the Master Station. No others have the same serial number as yours. You should record the number and other vital information here and retain this book as a permanent record of your purchase to aid identification in case of theft.
Date of Purchase
Dealer Purchases from
Dealer Address
Dealer Phone No.
Model No. IM-3303
Serial No.
11
USING THE MONITOR FUNCTION
The MONITOR function allows you listen to sounds from selected station locations. It is most frequently used to monitor an invalid’s or a child’s room. When a station is set to MONITOR, most sounds in that room will be transmitted to all stations in the RADIO/INTERCOM mode.
1. Determine the station that is to be placed into the MONITOR mode.
2. Set that station’s status switch to MONITOR.
3. Turn the station’s VOLUME control to maximum.
4. Set listening stations to RADIO INTERCOM.
5. Reset the STATION STATUS switch when monitoring is no longer necessary. NOTE: If program audio source is present during monitor, the program audio and the sounds heard in monitor are heard at the same time on all stations in Radio Intercom mode.
INTERCOM VOLUME CONTROL
The INTERCOM VOLUME control at the Master Station controls the intercom volume throughout the system.
Optional Accessories
ELECTRONIC DOOR CHIME: When a NuTone Electronic Door Chime
is connected to your IM-3303 Radio Intercom Master Station, the chime is heard at all stations in RADIO/INTERCOM and INTERCOM ONLY.
DOOR RELEASE: If an optional NuTone door release push button has been installed at the IM-3303 Master Station, use the button to open the door.
Resetting the Microprocessor
NOTE: Resetting the microprocessor will cause radio memory channels and clock
time to be lost.
Should the system not operate properly, the internal microprocessor may require resetting. To reset the microprocessor, use the point of a pen to press the reset button through the access hole behind the right lower door. See “Illustration and Master Station Controls” on pages 4 and 5.
Loading...
+ 4 hidden pages