NuTone 744FLNT User Manual
DESCRIPTION
TRIM RING BAFFLE:
Polymeric construction with matte white finish
•
Recessed styling, mounts flush with finished ceiling
•
LAMP:
Uses R30-shaped, 14W, high efficacy, compact fluorescent
•
lamp with GX24q-1 base (included)
Electronic ballast
•
BLOWER:
Plug-in, permanently lubricated, motor
•
Dynamically balanced centrifugal blower wheel for quiet,
•
efficient performance
Low RPM for quiet operation
•
HOUSING:
Fits in 2” x 8” construction
•
Rugged, 26 gage, galvanized steel construction
•
4" round, polymeric duct connector with 2" tapered sleeve and
•
no metallic clatter
Adjustable mounting brackets span up to 24"
•
CONTROLS: (purchase separately)
Model VS-96 - One rocker switch with "on" indicator light
•
Model VS-86SN - Two rocker switches - fits single outlet box
•
Model VS-66WH - 60-minute timer for fan and rocker switch
•
for light
U.L. Listed for use in insulated ceilings (TYPE I.C.)
U.L. Listed for use over bathtubs and showers when connected
to a GFCI protected branch circuit.
Architectural & Engineering Specifications
July 2006
Recessed
Fluorescent
Light / Fan
MODEL 744FLNT
SPECIFICATIONS
VOLTS AMPS* SONES CFM DUCT
120 0.7 1.5 70 4" Round
* Total Connected Load
HVI-2100 CERTIFIED RATINGS
comply with new testing
technologies and procedures
prescribed by the Home
Ventilating Institute, for off-theshelf products, as they are
available to consumers. Product
static pressure, based on tests conducted in AMCA’s
state-of-the-art test laboratory. Sones are a measure of
humanly-perceived loudness, based on laboratory
measurements.
REFERENCE QTY. REMARKS Project
performance is rated at 0.1 in.
NuTone, Inc., 4820 Red Bank Road, Cincinnati, OH 45227 (1-888-543-8687)
ARCHITECT’S SPECIFICATION
Light / Fan shall be NuTone Model 744FLNT as manufactured by
•
NuTone according to specifications listed:
Light / Fan shall have corrosion resistant steel housing and
•
adjustable mounting brackets.
Motor assembly to be removable and permanently lubricated.
•
Non-metallic damper/duct connector to be included.
•
Light and Fan to operate separately or in combination.
•
Light / Fan must use an R30-shaped, 14W, high efficacy, pin-
•
based, compact fluorescent lamp and an electronic ballast.
Air delivery shall be no less than 70 CFM and sound level no
•
greater than 1.5 Sones. All air and sound ratings shall be certified
by HVI.
Light / Fan must be U.L. and cU.L. Listed for use in insulated
•
ceilings (Type I.C.).
INSTALLATION
Complete installation instructions are included with each Recessed
Light / Fan.
Location
Architect
Engineer
Contractor
Submitted by Date
60F 99043767B
Loading...