Northern Industrial Tools 1961202 User Manual

Air Tools

ITEM# 1961202

1/2" Variable Speed Impact Wrench

USER'S MANUAL

Read carefully and understand RULES FOR SAFE OPERATION and instructions

before operating. Failure to follow the safety rules and other basic safety

precautions may result in serious personal injury.

Made in China

For technical questions and replacement parts, please call 1-800-222-5381.
Thank you very much for choosing a NORTHERN TOOL + EQUIPMENT CO., Product!
For future reference, please complete the owner's record below:
Model: _______________ Purchase Date: _______________
Save the receipt, warranty and these instructions. It is important that you read the
entire instruction sheet to become familiar with this product before you begin using it.
This product is designed for certain applications only. Northern Tool + Equipment
strongly recommends that this product is not modified and/or used for any
application other than that for which it was designed. If you have any questions relative
to a particular application, DO NOT use the product until you have first contacted
Northern Tool + Equipment to determine if it can or should be performed on the product.
Before using this product, please read the following instructions carefully.

Technical Specifications

Item

Drive Size

Free Speed

Max. Torque

Description Description

1/2"

7000 RPM

300 ft-lbs

Item

Air Consumption
Air Inlet Diameter
Max. Air Pressure

5.6 CFM

1/4"- 18NPT

90 PSI

SAVE THIS MANUAL

You will need this manual for the safety warnings and precautions, assembly, operating,
inspection, maintenance and cleaning procedures, parts list and assembly diagram.
Keep this manual and invoice in a safe and dry place for future reference.

WARNINGS AND SAFETY RULES

1.Wear proper clothing. Always use ANSI-approved safety impact goggles when
assembling or using this tool. Wear long sleeved shirts, long pants and hard-toed shoes.
Take off any loose fitting jewelry and keep long hair covered to prevent being caught in
moving parts.

2.Wear proper breathing protection. Remember that a "dust mask" is not a breathing
respirator. Use a respirator that uses charcoal filters for the best protection.

3.Keep work area clean and well lighted. A dim and/or cluttered work area invites
personal injury.

4.Keep children and pets away from work areas. Children can be a distraction and
should be supervised by an adult when near the work area. Never allow children to
play with this product even if it is turned off.

5.Store idle tools properly. Keep this tool out of the reach of children.

6.Do not use the Tool if under the influence of alcohol or prescription drugs. Doing so
may cause damage to the tool, or personal injury. Do not use this or any tool if you are
tired. Use common sense at all times.

7.Check for damaged parts. Before using this tool, carefully check for any parts that
may be missing or damaged and any other conditions that may affect the operation
of this tool. Replace or repair damaged and worn parts immediately using only
qualified repair facility.

8.Always use the proper tools. This tool was designed for a specific task. Do not alter
this tool, or use it for a purpose for which it was not intended.

9.Be careful when connecting/disconnecting air supply. It is recommended to use quick
disconnects (not included) rather than screw-on air connections.

1 of 4