Nortel Networks ATA 2 User Manual
Enterprise Edge ATA 2
User Guide
www.nortelnetworks.com
© 2000 Nortel Networks
P0908546 Issue 02
Contents
About Enterprise Edge ATA 2 5
What does Enterprise Edge ATA 2 do? 5
Feature List 6
Alternate Line 6
Call Forward 6
Call Park 6
Call Park Retrieve 6
Callback for Call Park 6
Call Pick-up (Directed) 6
Call Pick-up (Group) 6
Call Queuing 7
Camp-on 7
Conference Call 7
Conference Hold 7
Conference Consultation (Split Conference) 8
Disconnecting One Party 8
Hold Call (Exclusive) 8
Hold Call (Public) 8
Hotline 8
Last Number Redial 9
Line Pool Selection 9
Enterprise Edge Voice Messaging 9
Page (General) 9
Page (Intercom) 9
Page (External) 9
Page (Intercom/External) 9
Priority Call 10
Privacy Control 10
Restriction Override 10
Ring Again 10
Reply To a Ring Again Signal 10
Saved Number Redial 11
Send Message 11
Service Mode 11
System Speed Dial 11
Tones 11
P0908546 Issue 02 Enterprise Edge ATA 2 User Guide
4 Contents
Transfer 12
Blind Transfer 12
Transfer using announce 12
Transfer using Conference 12
T o Transfer an external call to a co-worker with a line appearance using
Hold 12
Trunk Answer from any Telephone 13
Voice Call 13
Data Communication 15
Set Tones to OFF 15
Auto-answer Modems and Answering Machines 15
Modem and FAX Transmission Compatibility 15
Troubleshooting for Data Applications 17
Enterprise Edge ATA 2 User Guide P0908546 Issue 02
About Enterprise Edge ATA 2
What does Enterprise Edge ATA 2 do?
Enterprise Edge Analog Terminal Adapter 2 (Enterprise Edge ATA 2) connects a
digital two-line display telephone port to a standard analog voice device, such as a
single-line telephone or a data communication device, such as a modem or facsimile
machine. Enterprise Edge ATA 2 provides on or off-premise service.
This guide describes:
• Enterprise Edge ATA 2 features used with the Enterprise Edge server
• Data Communication information
• Troubleshooting
All of the features available from Enterprise Edge ATA 2 are accessed by pressing
˚• on your telephone and pressing a feature or access code. The feature
list shows ˚• and the feature code. Where applicable, steps are included
to help use each feature. If your telephone does not have a ˚ button, you
must use the hook switch (located under the handset). The hook switch must be
pressed for approximately one half of one second.
If your telephone does not have a • or £ button, you must use dialpad numbers.
To indicate a • press ⁄. To indicate a £ press ‹.
For more information about feature operations, accessing feature operations or
feature codes, see your System Administrator.
P0908546 Issue 02 Enterprise Edge ATA 2 User Guide
6 About Enterprise Edge ATA 2
Enterprise Edge ATA 2 User Guide P0908546 Issue 02
Loading...