Nokia Mobile Holder CR-123 & Easy Mount HH-22 User Guide
Issue 1.
2
About your car holder
With the Nokia Mobile Holder CR-123 & Easy Mount HH-22, you can access your phone
easily at all times. Attach the holder to the windshield or dashboard of your car, and
you're ready to go.
Parts
1 Clamps
2 Holder
3 Bottom support
4 Clamp release lever
5 Tightening nut
6 Mounting plate
7 Mount
8 Suction cup
9 Mount locking lever
Attach the holder to the mount
Slide the holder onto the mount until it locks into place. To remove the holder from the
mount, slide the holder up until it comes off.
Attach the car holder to the windshield
Before you start, make sure that both the windshield and suction cup are clean and dry.
Make sure the mount locking lever is released.
1 Place the suction cup at the desired spot on the windshield, making sure the stem
of the mount is extending up and towards you
2 Press the suction cup evenly against the windshield, and press the mount locking
lever until it is closed.
3
Remove the holder from the window
Release the mount locking lever, and lift from the tab on the edge of the suction cup.
4
Attach the car holder to the dashboard
Before you start, make sure that the dashboard and the top of the mounting plate are
clean and dry.
1 Remove the protective film from the adhesive on the underside of the mounting
plate. Place the mounting plate on the desired spot on the dashboard. To make sure
there is a strong adhesive bond, press the plate down, firmly and evenly.
2 Make sure the mount locking lever is released, and position the car holder on the
mounting plate, with the mounting stem extending up and towards you.
3 Press the mount locking lever until it is closed.
Remove the holder from the mounting plate
Release the mount locking lever, and lift from the tab on the edge of the suction cup.
Adjust the holder angle
To avoid glare and view the screen of your phone more easily, you can adjust the angle
of the holder.
Tip: Holder not turning easily? To loosen the tightening nut, turn it clockwise.
Check periodically that the holder is securely in place. Re-tighten the tightening nut, if
necessary.
Place your phone in the holder vertically
1 Turn the holder so that the clamps are on the left and right and the bottom support
is pointing down.
Tip: Holder not turning easily? To loosen the tightening nut, turn it clockwise.
2 To widen the clamps, lift and hold the clamp release lever.
5
3 Pull the bottom support out slightly.
6
4 Place your phone in the holder and adjust the bottom support until the phone is at
a height where it is secure.
5 Push the clamps together, until the phone is firmly in place.
Make sure the clamps don't cover any important controls on your phone, such as the
power key.
Place your phone in the holder horizontally
1 Turn the holder so that the clamps are at the top and bottom.
Tip: Holder not turning easily? To loosen the tightening nut, turn it clockwise.
2 Pull out the bottom support completely.
3 To widen the clamps, lift and hold the clamp release lever.
4 Place your phone in the holder.
7
5 Push the clamps together, until the phone is firmly in place.
8
Make sure the clamps don't cover any important controls on your phone, such as the
power key.
Take care of your device
Handle your device with care. The following suggestions help protect your warranty
coverage:
•Do not drop, knock, or shake the device. Rough handling can break delicate
mechanics.
•Use only a soft, clean, dry cloth to clean the surface of the device.
General safety instructions
Read these simple guidelines. Not following them may be dangerous or illegal. For
further information, read the complete user guide.
Obey all local laws. Always keep your hands free to operate the vehicle while driving.
Your first consideration while driving should be road safety. Only operate the mounting
device or cell phone holder if it is safe to do so under all driving conditions.
When you install the mounting device or cell phone holder, make sure that they do not
interfere with or hinder the steering or braking systems or other systems used in the
operation of the vehicle (for example, airbags) or disturb your field of vision while
driving.
Check that the deployment of the airbag is not blocked or impaired in any way. Make
sure that the mounting device or mobile holder is not installed where you might come
in contact with it in the event of an accident or collision.
Periodically check that the suction cup at the bottom of the mounting device is firmly
attached to the windshield, especially if the ambient temperature changes a lot.
Do not place or remove a mobile phone while driving.
To learn more about how to use your product, or if you are unsure how your product
should work, see the support pages at www.nokia.com/support.
Recycle
For information on how to recycle your old products and where to find collectionVLWHV
go to www.nokia.com/werecycle, or call a contact center.
Recycle pack
aging and user guides at your local recycling scheme.
For more information on the environmental attributes of your device, go to
www.nokia.com/ecoprofile.
Copyright and other notices
DECLARATION OF CONFORMITY
Hereby, 0LFURVRIW0RELOH2\ declares that this CR–123&HH–22 product is in compliance with the essential requirements and
other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/
global/declaration/declaration-of-conformity.
ility of particular products may vary by region. Please check with your
commodities, technology or software subject to export laws and regulations from the US and other countries. D iversion
contrary to law is prohibited.
/Issue 1. EN-US
dealer for details. This device mayFRQWDLQ
9
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.