Nokia FAPr-hsp 5000 User Manual
FAPr-hsp 5000
User Manual
Copyright © 2012 Nokia Siemens Networks. All rights reserved.
Nokia is a registered trademark of Nokia Corporation, Siemens is a registered trademark
of Siemens AG. The wave logo is a trademark of Nokia Siemens Networks Oy.
Other company and product names mentioned in this document may be trademarks of
their respective owners, and they are mentioned for identification purposes only.
Nokia Siemens Networks Corporation, Karaportti 3, FI-02610 ESPOO, Finland
PN: xxxxxxxxx
Insert Barcode
Installation Procedure
1. Plug the power and network cables into the device.
2. Plug the network cable into the broadband router.
3. Plug the power supply into the main socket.
4. The green light will stop flashing when the device is ready
to use. It may take a few minutes to complete the
process. If the green light does not stop flashing after 30
minutes, please call the operator for help.
5.
For the complete User Manual, please log on to
http://www.nokiasiemensnetworks.com/manuals
Broadband
Router
Main
Socket
Power Cable
Network
Cable
Rear Panel
Power Supply
Device
Page 1 of 3
Package Contents
3G Access Point Ethernet cable Main power supply
LEDs
Rear Panel
Femto (Green / Red / Off)
This device has 1 LED.
Front-Mounted LED
LED State
LED State
Definition
Definition
Green
Red
Off
On
Fast Flashing
Single flashing light
On
No power.
Slow Flashing
Power on.
Product failure.
Initialization or temporarily out of service.
No router connection.
Sequence of two flashing light
Sequence of three flashing light
No Internet connection.
One or more calls are currently active.
RF issue. Local interference/poor service.
Sequence of four flashing light Over temperature.
Sequence of two flashing lights
No calls can be received currently.
Do not reset unless Service Provider advises you to
perform this task.
Use a standard LAN cable (RJ45 connector) to connect
the router.
Connect the supplied power adapter here.
Reset
Power Port
ETH Port
Reset
Power Port
ETH Port
Page 2 of 3
Loading...