2Contents
Contents
Safety 3
Get started 4
Your phone 4
Insert a SIM card and the battery 4
Remove the battery 5
Charge the battery 5
Switch on or off 5
Your phone 6
Keys and parts 6
Main features 6
Two SIM settings 7
Calls 7
Text input 7
Message 8
Contacts 9
Multi-phonebook 9
FM Radio 10
Flashlight shortcuts in standby
mode 10
PIN codes 10
Support 10
Product and safety information 11
Safety 3
Safety
Read these simple guidelines. Not following them may be dangerous or illegal. Read
the complete user guide for further information.
SWITCH OFF IN RESTRICTED AREAS
Switch the device off when mobile phone use is not allowed or when it may
cause interference or danger, for example, in aircraft, near medical
equipment, fuel, chemicals, or blasting areas.
ROAD SAFETY COMES FIRST
Obey all local laws. Always keep your hands free to operate the vehicle while
driving. Your first consideration while driving should be road safety.
INTERFERENCE
All wireless devices may be susceptible to interference, which could affect
performance.
QUALIFIED SERVICE
Only qualified personnel may install or repair this product.
KEEP YOUR DEVICE DRY
Your device is not water-resistant. Keep it dry.
PROTECT YOUR HEARING
Listen to a headset at a moderate level, and do not hold the device near your
ear when the loudspeaker is in use.
4Get started
Get started
Your phone
You can insert two SIM cards into your phone, but only one card can be active at a time.
You can switch from one number to the other without switching off your phone. You
can use the active SIM card to view or call or send messages to the contacts saved on
the inactive SIM card.
The length of time required to switch between the SIM cards may vary, depending on
the network signal strength and the amount of available memory on your SIM card.
Insert a SIM card and the battery
1 Place your finger in the recess at the bottom of the device, and carefully lift and
remove the back cover (1).
2 Using a finger grip (2), carefully lift a SIM card holder.
3 Insert the SIM card (3).
4 Close the SIM card holder, and press it to lock it into place (4).
5 Insert the battery (5), and replace the back cover (6, 7).
To insert a second SIM card, follow the same steps.
This phone is intended for use with the BL-5C battery.
Get started 5
Remove the battery
Safe removal. Always switch the device off and disconnect the charger before removing
the battery.
Charge the battery
Your battery has been partially charged at the factory. If the device indicates a low
charge, do the following:
1 Connect the charger to a wall outlet.
2 Connect the charger to the device.
3 When the device indicates a full charge, disconnect the charger from the device,
then from the wall outlet.
Tip: To save energy, unplug the charger when the battery is fully charged.
You do not need to charge the battery for a specific length of time, and you can use the
device while it is charging. If the battery is completely discharged, it may take several
minutes before the charging indicator appears on the display or before any calls can be
made.
Switch on or off
Press and hold the end key.
Use the phone only in its normal operating position.
Avoid touching the antenna area unnecessarily while the antenna is transmitting or
receiving. Contact with antennas affects the communication quality and may cause a
higher power level during operation and may reduce the battery life.