Nokia Asha 500 Dual SIM RM 934, Asha 500 RM-973, Asha 500, RM 934, RM-972 Service Manual

Check the repair

policy before

performing any

mechanical repair

on Service Level

1&2!

Service Manual for L1 andL

2

Nokia Asha 500 Dual SIM

RM-934, RM-97

2

Nokia Asha 500

RM-973

Key features

z

2.8" QVGA Display

z

Capacitive touch screen and back key

z

2 MP Camera

z

Wi-Fi support

z

Micro SD card support up to 32 GB

Version 1.0

Exploded view Disassembly steps Assembly hints

Solder components Service devices Product controls and interfaces

Service concept

©2013 Nokia | Nokia Internal Use only | All Rights Reserved.

More More More

More More More

More

Service Manual Level 1 and 2

Nokia Asha 500 Dual SIM, Nokia Asha 500

RM-934 RM-972 (Dual SIM), RM-973 (Single SIM)
Version 1.0

Exploded view

EARPIECE GASKET

I0004

RELEASE BUTTON

I0022

A-COVER

I0001

EARPIECE

I0003

DISPLAY

I0014

LIGHT SWAP PWB

I0008

CAMERA

I0006

D-COVER

I0020

BT ANTENNA

I0018

SIM LID

I0019

TYPE LABEL

I0013

TOUCH IC GASKET

I0007

TOUCH PANEL
I0002

DISPLAY CONDUCTIVE
ADHESIVE
I0012

TOUCH WINDOW
PROTECTIVE TAPE
I0005

IHF SPEAKER
I0015

SPEAKER MESH
I0017

SPEAKER BOTTOM GASKET
I0016

GSM ANTENNA MODULE
I0021

B-COVER
I0024

BB SHIELDING LID
I0009

RF SHIELDING LID
I0010

WLAN SHIELDING LID
I0011

SCREW TORX+ SIZE 6

M1.6 x 4.3

I0023

LIGHT SWAP PACKAGE

(I0006 - I0013)

2

D-COVER ASSEMBLY

(I0016 - I0020)

3

A-COVER ASSEMBLY

(I0001 - I0005)

1

Only available
as assembly

Not reuseable
after removal

Repair/swap
only in level 3

©2013 Nokia | Nokia Internal Use only | All Rights Reserved.

Service Manual Level 1 and 2

Nokia Asha 500 Dual SIM, Nokia Asha 500

RM- 934 RM -972 (Dual SIM), RM -973 (Single SIM)
Version 1.0

Disassembly steps

1) For disassembling you need the Nokia Standard toolkit version 2. You will also need the camera
removal tool SS-276.

2) Protect the TOUCH PANEL with protective film.

3) Push from the RELEASE BUTTON to release the B-COVER.

4) Remove the B-COVER.

5) Unscrew the four Torx+ size 6 screws in the order shown.

6) Start releasing the D-COVER from the top left corner with the SRT-6 to detach the two shown clips.

7) Then release the other clip on the left side of the device.

8) Then release the two clips on the right side of the device

9) Remove the D-COVER.

10) Open the DISPLAY connector. Be careful not to damage the connector or any components nearby.