Nokia is a registered trademark of Nokia Corporation.
Power Macintosh and Macintosh are registered trademarks of Apple Computer, Inc.
Microsoft, Windows, Windows NT, and the Windows logo are registered trademarks of Microsoft
Corporation in the United States and other countries.
OnView, ViewMatch, and ViewMeter are registered trademarks of ViewSonic Corporation.
E
NERGY STA R is a registered trademark of the U.S. Environmental Protection Agency (EPA).
VESA is a registered trademark of the Video Electronics Standards Association. DPMS and DDC
are trademarks of VESA.
For Your Records
The serial number of this product is on the back of the monitor. Write the serial
number of this unit in the space below and keep this booklet as a permanent
record of your purchase to aid in identification in the event of theft or loss.
Product Name:Nokia 730C
Model Number:VCDTS21511-2
Document Number:730C_UG_80
Serial Number: __________________
Purchase Date:___________________
E
N
G
L
I
S
H
Product Disposal at end of Product Life
Please help preserve our environment. Please dispose of this product properly at the end of its
useful life. Your local waste disposal company may provide information about proper disposal.
Nokia 730C
1
Power Cord Safety Guidelines
The power cord for this unit has been packed separately and has been selected according to
the country of destination and must be used to prevent electric shock.
Use the following guidelines if it is necessary to replace the original cord set.
Caution : Use a power cable that is properly grounded. Always use the AC cords listed
below for each area :
USA ...........................UL
Canada ......................CSA
E
N
G
L
I
S
H
In other areas, use AC cord which meets local safety standards.
The female receptacle of the cord set must meet CEE-22 requirements and will look like
Figure 1 below:
For the United States and Canada
In the United States and Canada the male plug is a NEMA5-15 style (Figure 2) UL Listed
and CSA Labelled. For units which are mounted on a desk or table, type SVT or SJT cord
sets may be used. For units which sit on the floor, only SJT type cord sets may be used. The
cord set must be selected according to the current rating for your unit. Please consult Table
A below for the selection criteria for power cords used in the United States and Canada.
Cord Type Size of Conductors In CordMaximum Current Rating of Unit
SJT 18AWG10Amps
SVT 18AWG10Amps
AC PLUG CORD PRECAUTIONS FOR THE UNITED KINGDOM
FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY.
IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET OUTLET THEN THE
PLUG SHOULD BE CUT OFF AND DISPOSED OF SAFELY.
THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF THE CUT OFF PLUG IS
INSERTED INTO AN APPROPRIATE SOCKET.
If a new plug is to be fitted, please observe the wiring code as shown below.
If in any doubt, please consult a qualified electrician.
WARNING: THIS APPLIANCE MUST BE EARTHED.
IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:
Green-and-Yellow:Earth
Blue:Neutral
Brown:Live
If the coloured wires of the mains lead of this appliance do not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the
plug which is marked by the letter E or by the Earth symbol
AND-YELLOW.
The wire which is coloured BLUE must be connected to the terminal in the plug which is
marked with the letter N or coloured BLACK. The wire which is coloured BROWN must be
connected to the terminal in the plug which is marked with the letter L or coloured RED.
Germany ....................VDE
Switzerland ................SEV
Britain .........................BASEC/BS
Japan .........................Electric Appliance Control Act
Figure 1
Figure 2
16AWG12Amps
14AWG12Amps
17AWG12Amps
or coloured GREEN or GREEN-
2
Nokia 730C
For Other European Countries
In Europe you must use a cord set which is appropriate for the receptacles in your country.
The cord set is HAR-Certified, and a special mark that will appear on the outer sheath, or on
the insulation of one of the inner conductors.
If you have any questions concerning which proper power cord to use, please consult with
the dealer from whom you purchased your monitor.
FCC Information
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
E
N
G
L
I
S
H
To assure continued FCC compliance, the user must use the grounded power supply cord
and the provided shielded video interface cable with bonded ferrite cores. Also, any
unauthorized changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this device.
Power Supply Cord USA
For units with 100 - 120V input voltage in the USA, use the following :
UL Listed and CSA Certified Type SVT or SJT No. 18/3 AWG rated 125Vac 7A min.
One end terminated in a molded on parallel blade, grounding attachment cap or hooded attachment cap
(15A, 125V configuration), other end terminated in a mold-on appliance coupler.
Notice for Germany
The X-rays generated in this unit are shielded sufficiently. High voltage: Max. 30.0 kV. For ergonomic reasons, we
recommend that you do not display blue characters on a dark background. Doing so may produce insufficient
contrast that could lead to eye strain.
Notice for Japan
This equipment falls under the class B information Technology Equipment based on the standard established by the
self-imposed Control Council for Radio interference through infor mation-processing Equipment (VCCI). This
equipment is designed to be used in a household environment, However, if it is used near radio and television
receiver units, radio disturbances can occur. Use this equipment appropriately according to the instruction manual.
CE Conformity
The device complies with the requirements of the EEC directive 89/336/EEC as
amended by 92/31/EEC and 93/68/EEC Art.5 with regard to “Electromagnetic
compatibility”, and 73/23/EEC as amended by 93/68/EEC Art. 13 with regard to
“safety”.
Congratulations on your purchase of a Nokia 730C color monitor.
Important! Save the original box and all packing material for future
shipping needs.
NOTE: This product was designed for operation in the magnetic fields of the
hemisphere where it was purchased. Also, the word “Windows” in this user
guide refers to the following Microsoft operating systems: Windows ‘95,
Windows NT, Windows ‘98, Windows 2000 and Windows ME (Millennium).
Package Contents
Your Nokia 730C package includes:
•Nokia 730C monitor
•Power cord
•Video cable (detachable)
IMPORTANT: The supplied INF file assures compatibility with Windows operating
systems, and the ICM file (Image Color Matching) ensures accurate on-screen colors.
We recommend that you install both files.
• For CD-ROM: Insert the CD-ROM into your system, wait for it to auto-star t, select
“Monitor Drivers,” and follow the on-screen instructions.
• For diskette: Insert the diskette into your system, run setup.exe, and follow the on-
screen instructions.
•User’s guide
•INF and ICM installation files
on CD-ROM or diskette
E
N
G
L
I
S
H
Precautions
• For best viewing conditions sit at
least 18" from the monitor.
• AVOID TOUCHING THE SCREEN
WITH YOUR FINGERS. Oils from
the skin are difficult to remove.
•
NEVER REMOVE THE REAR
COVER. The monitor contains highvoltage parts. You may suffer serious
injury if you touch these parts.
• Avoid exposing the monitor to direct
sunlight or another heat source. The
monitor should be facing away from
direct sunlight to reduce glare.
• Always handle your monitor with
care when moving it.
Nokia 730C
•
Choose a well ventilated area to
position your monitor. Do not place
anything on the monitor that prevents
adequate dissipation of heat.
•
Ensure the area around the monitor is
clean and free of moisture.
•
Keep the monitor away from magnets,
motors, transformers, speakers, and
televisions.
•
Do not place heavy objects on the
monitor, video cable, or power cord.
•
If smoke, abnormal noise, or strange
odor is present, immediately switch the
monitor off and call your dealer. It is
dangerous to continue using the
monitor.
Getting Started
5
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.