JBV-1 Docking StationDA-12 Docking Station Adapter
07702980770603
The Docking Station and the Docking Station Adapter
are needed for Mbus, Fbus, RF, and audio connections.
This setup allows connection between flash prommers.
When the audio box is connected, it has to be connected to the phone’s audio connector. The Docking
Station can be powered by FPS-8 or external power
supply.
The flash adapter allows FBUS/MBUS connections for
flashing.
JBA-12 Audio BoxCPL-8 GPS/RF Coupler
07705360770475
The JBA-12 is required for audio testing at authorized
service centers.
CPL-8 allows testing of the GPS antenna at AMS locations.
This cable is used with FLS-4S or FLC-20 for bottomconnector flashing.
PKD-1 SW Security Device
0750018
SW security device (PKD-1) is a hardware device that,
when connected to the parallel (LPT) port of the PC,
enables the use of service software. Without the dongle present, it is not possible to use the service software. Printers or other peripheral devices can be
connected to the PC through the dongle, if needed.
Caution: Make sure that you have switched off the PC
and the printer before making connections!
This jig allows phone PWB-level service and troubleshooting for authorized service centers.
Tightened performance specifications require more precise equipment and methods for
testing and alignment. Manual tuning can’t provide accurate results for the RH-34,
which means that this test has to be automated.
These setups are intended to be with with the Phoenix Service Software. Both manual
testing and automated tuning are permitted with Phoenix Service Software.
1Vector Signal AnalyzerAgilentE4406A1Options B78, BAC and BAE
2Signal GeneratorAgilentE4421B1Digital signal generator with
high stability oscillator and high
spectral purity
3Momentum SeriesAgilent8960C1CDMA tester for IS-95, IS-2000,
and AMPS protocols
4Power SupplyKeithlyK23062Programmable with sense wire
5Win2000 PCDell with Pentium III or above,
network card, 256M RAM, 20GB
HD, CD-ROM, etc.
6NI-GPIB InterfaceNIGPIB-USB-A2USB to GPIB adapter (184983G-
01)
7Docking StationNokiaJBV-11Consult your local Nokia After
Market Services office for more
information
8RF SwitchesGreen HillTVi99011Consult your local Nokia After
Market Services office for more
information
Note: A Test Sequence File is required to perform “Auto tune” on this phone. In addition, Phoe nix needs to have the Auto Tune function installed. Consult you local Nokia After Market Services office more information.
GPS Testing Engine
This setup will be used for testing of the GPS Engine at Nokia Authorized Service Centers.
Both Galvanic and Radiated tests will be supported. The GPS Test component in Phoenix
will provide functionality to perform these tests. Refer to the Troubleshooting - GPS section for more details regarding GPS Engine troubleshooting.