Nokia 6250 Service Bulletin 018

CONFIDENTIAL
1 (3)
Nokia Mobile Phones Service Bulletin No. SB-018/28.03.01 Technical Support, Europe & Africa
NHM-3
FLEX FOIL SOLDERING INSTRUCTIONS
LCD module (4850151) is connected to PWB with flexible printed cable (flex foil). LCD module needs to be changed, if it is broken or i f uBGA components need to be changed. The use of new LCD is recommended, if the old LCD module had to be removed. Following tools and instructions are recommended to be used and followed when changing flex foil by manual soldering. Note that METCAL-station provides special technology and constant temperature of the tip, which allows this soldering to the performed accordingly.
Tested and recommended tools: Metcal Soldering Station MX 500 (SmartHeat Technology) http://www.metcal.com/products/1.2.1.htm
NHM-3 SB-018
Metcal Tip cartridge:
SMTC 162 (22.1 mm; max 412 °C)
Manufacturer:
http://www.metcal.com/
(belongs to OK International)
Working procedure
1. Desoldering a flex foil Release of flex foil can be done by desoldering with the Metcal solder iron
with the same tip as it is used for soldering of the flex foil. The solder tip can glide forwards between the flex and pads after approximately 3-5 seconds without pressure. The use of solder iron is recommended instead of hot air.
CONFIDENTIAL
2 (3)
2. Prepare the PWB and a new flex foil
- Clean the contacts on the PWB with the Metcal-Tip and put some flux on the contacts
- Bend the flex foil a little bit at the perforation. Don't touch the contacts with your fingers! Now it's easier to hold the flex foil in the right position
NHM-3 SB-018
Loading...
+ 1 hidden pages