Nokia 1203, 1202 User Manual

Nokia 1202/1203 User Guide

9211638

Issue

4

2Contents

Contents

Safety 3

Get started 4

Open the back cover 4
Insert the SIM card and battery 4
Remove the SIM card 4
Charge the battery 4
Switch on and off 5

Your phone 5

Keys and parts 5
Main features 6
Make and answer a call 6
Write text 7
Message 8
Contacts 8
Multi-phonebook 8
Turn the flashlight on or off 9

General information 10

Accessories 10

Battery 10

Battery and charger information 10
Nokia battery authentication
guidelines 11

Taking care of your device 11

Recycle 12

Additional safety information 12

Small children 12
Operating environment 12
Medical devices 12
Vehicles 13
Potentially explosive environments 13
Emergency calls 13
Certification information (SAR) 13

Safety 3

Safety

Read these simple guidelines. Not following them may be dangerous or illegal. Read
the complete user guide for further information.

SWITCH ON SAFELY

Do not switch the device on when wireless phone use is prohibited or when
it may cause interference or danger.

ROAD SAFETY COMES FIRST

Obey all local laws. Always keep your hands free to operate the vehicle while
driving. Your first consideration while driving should be road safety.

INTERFERENCE

All wireless devices may be susceptible to interference, which could affect
performance.

SWITCH OFF IN RESTRICTED AREAS

Follow any restrictions. Switch the device off in aircraft, near medical
equipment, fuel, chemicals, or blasting areas.

QUALIFIED SERVICE

Only qualified personnel may install or repair this product.

ACCESSORIES AND BATTERIES

Use only approved accessories and batteries. Do not connect incompatible
products.

WATER-RESISTANCE

Your device is not water-resistant. Keep it dry.

4Get started

Get started

Open the back cover

Press the release button (1), slide the back cover upwards (2), and remove it.

This phone is intended for use with the BL-4C battery.

Safe removal. Always switch the device off and disconnect the charger before removing
the battery.

Insert the SIM card and battery

1 Lift the battery, and remove it (1).
2 Insert the SIM card (2). Ensure that the gold-coloured contact area is facing down

and the SIM card is inserted with the bevelled corner facing the bottom of the device.

3 Replace the battery and back cover (3, 4).

Remove the SIM card

Press the release spring (1) and slide out the SIM card (2).

Charge the battery

Your battery has been partially charged at the factory. If the device indicates a low
charge, do the following:

1 Connect the charger to a wall outlet.

Your phone 5

2 Connect the charger to the device.
3 When the device indicates a full charge, disconnect the charger from the device,

then from the wall outlet.

Tip: To save energy, unplug the charger when the battery is fully charged.

You do not need to charge the battery for a specific length of time, and you can use the
device while it is charging. If the battery is completely discharged, it may take several
minutes before the charging indicator appears on the display or before any calls can be
made.

Switch on and off

Press and hold the end key.

Use the phone only in its normal operating position.

Your device may have internal and external antennas. Avoid touching the antenna area
unnecessarily while the antenna is transmitting or receiving. Contact with antennas
affects the communication quality and may cause a higher power level during operation
and may reduce the battery life.

Your phone

Keys and parts

1

2 Display

3 Selection keys

4 Navi™ key; hereafter referred to as

5 Call key

6 End/Power key

7 Keypad

Earpiece

scroll key