FOUR CHANNEL POWER DMX DIMMER PACK
USER'S MANUAL
INTRODUCTION:
The unit is a four channel power DMX dimmer pack . It is controlled by analog input from 0v to 10v
voltage or DMX-512. It provide a power supply for analog controller. We recommend that you take
time to read this manual fully before you attempt to use the unit.
Specification:
Operation:
Power input........................................................................Ac 230v ~50Hz , 16A.
Power output......................................................................Per channel 5 A, total 16A.
Analog input ......................................................................0---10v.
Power supply.....................................................................15V,500mA
DMX input........................................................................3pin XLR male socket
DMX output......................................................................3pin XLR female socket.
！！
Fuse ..................................................................................F 6.3A 250V,5X20MM. 4 purchase
！！
Circuit breaker .................................................................16A.
Dimension.........................................................................318x165x96mm
Weight...............................................................................2.95kg
1. You must fixed the unit, then put the circuit breaker on off. According to the diagram to connect the
analog controller or DMX controller . Analog controller with 8 pin cable and DMX controller with
special cable . Put the output of controller to minimum.
GND
IN
NC
CH4
CH3
Analog input: DC 0-10V
Through
DC +15V 500mA
NC
CH1
CH2
ＲＩＳＫ ＯＦ ＥＬＥＣＴＲＩＣ ＳＨＯＣＫＲＩＳＫ ＯＦ ＥＬＥＣＴＲＩＣ ＳＨＯＣＫ
NC
CH3
GND
CH4
DMX IN
1
DMX
DMX OUT
3
2
33
2
1
1: GND
2: DATA " +"
3: DATA " - "
DC +15V 500mA
NC
CH1
CH2
To analog controller
2. Connect loading on output sockets .
3. All connection is ok ,you can connect to main power then turn on the circuit breaker .
4. To adjust the output of controller , the corresponding load from black to light.
FUNCTION
1
2
3
4
5
6
7
8
9
10
DMX ADDRESS
1
2
8
4
16
Function
32
64
128
256
any one of DIP switch 1-9 is on, DMX parallel
All of DIP switch 1-9 is off, auto parallel
any one of DIP switch 1-9 is on ,DMX
All of DIP switch 1-9 is off , Auto
1
0
5. DMX controller and analog controller can
be used together. which single is stronger,
which single control output loading.
DMX ADDRESS
1
2
3
4
5
6
7
1
0
0
0
0
0
0
0
1
0
0
0
0
0
1
1
0
0
0
0
0
0
0
1
0
0
0
0
1
0
1
0
0
0
0
1
1
1
1
1
1
1
8
9
0
0
0
0
0
0
0
0
0
0
1
1 511
Start address
1
2
3
4
5
CH4 CH3 CH2 CH1
Power
DMX signal
It is blinking when the controller
is receiving DMX single.
！！
Caution:
1. To prevent fire or shock hazard, do not expose this apparatus to rain or moisture.
2. This apparatus must be earthed.
3. Do not try to repair it when the circuit is out of order ,send back to you supplier for repairing.
Loading...