Kornmarksvej 1 | DK-2605 Broendby | Denmark|Tel.: (+45) 4323 8100
One - Instructions for use
Caution: Read the instructions before using the machine
128350056 b (11.2017)
Safety Instructions
tric cable is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualifi ed
Before fi rst use of the machine, read the
instructions carefully. Save instructions for
later use.
Warnings Do not use the machine without dust
bag and fi lters properly fi tted.
This machine is not
intended for the suction of hazardous materials or gas,
doing so may expose people to serious health risks.
The machine must not be used for the suction of
water or other liquids.
such as needles or pieces of glass.
Do not pick up sharp objects
Do not pick
up anything that is burning or smoking such as cigarettes, matches or hot ashes.
Use and store this
machine indoors and in a dry environment, 0 °C to 60
°C.
Do not use the machine outdoors. When
activating the automatic cable rewind, care must be
taken as the plug at the end of the electric cable can
swing during the last part of the rewinding. It is
recommended that you hold on to the plug while
rewinding. Do not handle the machine with wet
hands.
Turn off the machine before unplugging.
To unplug, grasp the plug, not by pulling on the
electric cable. Do not carry or pull the machine by the
electric cable.
The machine must not be used if
the electric cable shows any sign of damage. Regularly inspect the electric cable for damage, in particular if it has been crushed, shut in a door or run over.
persons in order to avoid a hazard.
rotating parts by hand when using turbo nozzle.
This appliance can be used by children aged from
8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe
way and understand the hazards involved. Do not
allow children to c
lean the appliance or perform user
maintenance without supervision.
be supervised to make sure that they do not play with
the appliance.
batteries.
Remove rechargeable batteries from
the appliance before charging.
types of batteries or new and used batteries.
attention to the correct polarity when inserting batteries.
Remove exhausted batteries from the appliance and dispose of them safely.
is to be stored unused for a long period, remove the
batteries.
Do not short-circuit the supply terminals.
Service and maintenance Store the machine indoors
and in a dry environment. ● Change the pre-fi lter with
every fourth dust bag. ● Clean the machine surface
with a dry cloth or a damp cloth with a little cleaning
agent. ● Order original accessories from a local dealer.
● For service, contact your local dealer.
Do not use the machine if it appears faulty. Have
the machine inspected by an authorized service centre if the machine has been dropped, damaged, left
outdoors or has been exposed to water.
No
changes or modifi cations to the mechanical or electrical safety devices should be made.
All repair
must be carried out by an authorized service centre.
Use only original dust bags, original fi lters and
original accessories from your local dealer. Use of
unautho rized dust bags and fi lters will void the warranty.
Turn off the machine and unplug before
Responsibility Nilfi sk disclaims all responsibility for
all damage caused by incorrect use or modifi cation
of the machine. Please refer to our website at www.
consumer.nilfisk.com for further instructions and
information on use.
WEEE The symbol
may not be discarded together with household waste,
but must be collected separately. Please dispose
old appliances at the applicable collection point for
recycling.
starting dust bag or fi lter change, grasp the plug, not
by pulling on the electric cable.
If the supply elec-
Do not touch
Children must
Do not charge non-rechargeable
Do not mix diff erent
Pay
If the appliance
indicates that this appliance
3
1
2
13
11
12
10
4
6
7
5
8
9
19
14
15
16
17
18
The diff erent models of the vacuum cleaners can include diff erent nozzles
.
Overview
1 Parking bracket
2 Filter
3 Carrying handle
4 Cable rewinding knob
5 On/off button
6 Power level button
7 Dust bag indicator, fi lling
8 Accessory lid
9 Open/close button, dust container
10 Upholstery nozzle
11 Brush nozzle
12 Pre-fi lter holder
13 Dust bag
14 Hard fl oor nozzle (only on selected models)
15 Combination nozzle
16 Turbo nozzle (only on selected models)
17 Bent tube
18 Sliding valve on bent tube
19 Hose storing strap
2
Changing the dust bag
The dust bag indicator turns completely red when the
dust bag needs to be changed.
Always use original dust bags.
3
Changing the pre-fi lter
The pre-filter protects the motor by absorbing micro-particles that the dust bag can not keep. Change
the pre-fi lter with every fi fth dust bag. The pre-fi lter is
located behind the dust bag. Always use original fi lters.
4
Changing the (H)EPA fi lter
The (H)EPA fi lter cleans the exhaust air from micro
particles the dust bag can not keep. The (H)EPA fi lter
can not be brushed or washed clean if not mentioned.
Change the (H)EPA fi lter once a year.
4a
One & One Reach:
Open the fi lter door by pressing the button and pulling
the door out. Place the new fi lter in the frame. Press
the fi lter door in place again with a hard fi nger pressure.
Instructions for use
Before using the machine make sure that the voltage
shown on the rating plate underneath the machine
corresponds with the mains voltage.
The machine is supplied with dust bag and pre-fi lter.
1
Numbers
Start and stop
Start
Pull out the electric cable and plug the machine to a
wall socket.
Push the On/Off button and adjust the power level.
Stop
Turn off the machine and unplug. Unplug by grasping
the plug, not by pulling on the electric cable.
1
Connecting hose, tube and nozzles
refer to illustrations.
4b
One Prime & One Clean Air:
Open the fi lter door by pulling out the catch. Remove
the door. Place the new fi lter in the frame and close the
fi lter door again. Lock the door by pushing the catch
back in place.
Adjust the suction power
Sliding valve on the bent tube
The suction power is maximal with the sliding valve
closed and minimal when all open. Adjust the suction
power by putting the sliding valve in the desired position.
1. Insert the hose connector into the suction inlet.
2. Connect the bent tube to the tube.
3. Connect the tube to the nozzle.
4. The tube is telescopic and can be adjusted to your
height. Push the adjusting button to extend the tube,
and pull back to shorten to desired length.
Change of dust bag and fi lters
The size and quality of the dust bag and fi lters aff ect the
machine effi ciency. Use of non original dust bags or non
original fi lters can cause restricted air fl ow which may
lead to machine overload. Using non-original dust bag
or fi lters will void the warranty.
Power regulation
The suction power is adjusted by turning the button on
the machine.
Tip: Adjust smaller suction power to reduce noise and
pull force.
5
Parking the tube and nozzle
There are two grooves for parking. One located on the
underside of the machine to use when machine stands
on the back. The other on the back of the machine, to
be used when the machine is standing on its wheels.
Trouble shooting
Repair or service of electrical components as electric
cable or motor, must only be carried out by an authorized service center.
If the machine
does not start
See to that the plug is correctly fi tted to the wall socket.
6
Storability
Release the hose strap on the front of the machine.
Then raise the transport handle and wrap the hose
around the machine. Remount the strap.
Thermal fuse
The machine is fi tted with a thermal fuse, which prevents the machine from overheating. If the thermal fuse
blow, the machine automatically switches off the motor
and must cool before it can be started again.
Restart
1. Turn off the machine and unplug from the wall socket.
2. Ensure that nothing blocks the air fl ow through hose
handle, hose, tube, nozzle, dust bag or fi lters.
3. Let the machine cool.
4. Plug in the machine again and push start button.
The machine will not start until cool enough. If the
machine does not start, turn it off and unplug. Try
again in a while.
Cleaning tips
7
Upholstery nozzle
Use the upholstery nozzle for upholstered furniture.
8
Brush nozzle
Use the brush nozzle for curtains and window sills.
9
Hard fl oor nozzle
Use the nozzle for hard fl oors.
10
Combination nozzle
Adjust the combination nozzle depending on type
of fl oor.
11
Mini Turbo nozzle
Use the Mini turbo nozzle for effi cient carpet
cleaning.
The upholstery and brush nozzles are located under
the accessory lid. The accessory lid is opened by pressing the release button downwards. The lid is closed
manually.
A fuse in the building may have
blown and needs to be changed.
The electric cable or plug can be
damaged and must be repaired by
an authorized service center.
Reduced suction power
If the machine
stops
The dust bag can be full and needs
to be changed, see instructions.
The pre-fi lter or the (H)EPA fi lter
can be blocked and have to be
changed, see instructions.
The hose handle, hose, tube or
nozzle can be blocked and needs
to be cleaned.
The thermal fuse may have blown,
see instructions.
Service and maintenance
• Store the machine indoors and in a dry environment.
• Change the pre-fi lter with every fi fth dust bag.
The dust bag package includes fi ve dust bags
and one pre-fi lter.
• Change the (H)EPA fi lter once a year.
• Clean the machine surface with a dry cloth or a
damp cloth with a little cleaning agent.
• Order original accessories from a local dealer
• Service – contact your local dealer.
Recycling and scrapping
Recycle the wrapping and scrap the machine and the
electric cableaccording to recommendations from the
local authorities.
Cut the electric cable as short as possible to avoid that
someone gets injured on the scrapped machine.
Environmental commitment
This machine is designed with the environment in mind.
All plastic parts can be used for recycling.
Responsibility
Nilfi sk disclaims all responsibility for all damage caused
by incorrect use or modifi cation of the machine.
The diff erent models of these vacuum cleaners
can include diff erent nozzles.
Guarantee and service
This Nilfisk One Series vacuum cleaner is covered
by a two (2) year guarantee on the machine, which
covers the motor, cable rewinder, switch and casing.
The nozzles, fi lters, hoses, tubes and other accessories
are covered twelve months due to manufacturing fault
only and excludes wear and tear.
The guarantee includes spare parts and labour costs,
and covers manufacturing and material defects that
may occur during normal domestic use.
Service under the guarantee will only be performed
if it can be proven that the defect occurred within the
product’s guarantee period (a correctly completed
guarantee certifi cate or printed/stamped cash register
receipt with date and product type) and on the condition
that the vacuum cleaner was bought as a new product
and distributed by Nilfi sk.
In the event of the repair of defects, the customer must
contact Nilfi sk to be directed to a service agent at the
customers own expense. Upon completion of any repairs necessary, the vacuum cleaner will be returned to
the customer at the risk and expense of Nilfi sk.
Addendum Australia
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for a major failure
and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have
the goods repaired or replaced if the goods fail to be
of acceptable quality and the failure does not amount
to a major failure.
Nilfi sk vacuum cleaners for domestic use are warranted
for 2 years from the date of purchase by:
Nilfi sk Pty Ltd
Unit 1/13 Bessemer Street
Blacktown NSW 2148
Phone: 1300 556 710
E-mail: sales@nilfi sk.com.au
Find your local service agent here:
http://www.nilfi sk.com.au.
The bene fi ts under this warranty are in addition to your
national law of sale.
The guarantee does not cover:
• normal wear and tear of accessories and fi lters
• defects or damage occurring as a direct or indirect
result of incorrect use - such as the vacuuming of
rubble, hot ashes or carpet deodorant powder
• abuse, loss or lack of maintenance as described in
Instructions for use
• plaster dust
• saw dust
• water
• if the machine has been used for home renovations
Nor will it cover incorrect or poor configuration,
i.e. setting up or connection, nor fire-damage, fire,
lightning strike or unusual voltage fl uctuations or any
other electrical disturbances such as defective fuses
or defective electrical installations on the supply grid,
and defects or damage in general that Nilfi sk consider
to be the result of causes other than manufacturing and
material defects.
The guarantee becomes void:
• if a defect is caused by the use of non-original Nilfi sk
dust bags and fi lters
• if the identity number is removed from the vacuum
cleaner
• if the vacuum cleaner has been repaired by a nonNilfi sk authorized dealer
• if the machine is used in a commercial environment,
i.e. building contractors, cleaning contractors, professional trades or any other non-domestic usage
1
2
3
4a
4b
5
6
7
8
YSIZEXSIZE
9
10
11
SALES COMPANIES
HEAD QUARTER
DENMARK
Nilfi sk A/S
Kornmarksvej 1
DK-2605 Broendby
Tel.: (+45) 4323 8100
Website: www.nilfi sk.com
AUSTRALIA
Nilfi sk Pty Ltd
1/13 Bessemer Street
Blacktown NSW 2148
Tel.: 1300 556 710
Website: www.nilfi sk.com.au
NEW ZEALAND
Nilfi sk Limited
Suite F, Building E
42 Tawa Drive
0632 Albany, Auckland
Tel.: (+64) 9 414 1996
Website: www.nilfi sk.com
Loading...