Niles Audio RVL-6 RMP User Manual

Installing the

RVL-6 RMP

Niles Audio Corporation 12331 SW 130th Street Miami, Florida 33186 Tel: (305) 238-4373 Fax: (305) 238-0185

© 1999 Niles Audio Corporation. All rights reserved. Because Niles constantly strives to improve the quality of its products, Niles reserves the right to change product specifications without notice. Niles and the Niles logo are registered trademarks of Niles Audio Corporation. Printed in the USA 5/96 DS00171A

www.nilesaudio.com

Step 1

CAUTION!

Unit must be unplugged before cover is removed

A: Remove screws from

the RVL-6 chassis

B: Raise the cover off

of the unit

Step 2

C: Unplug the ribbon

connector, pull away from the front panel

D: Remove screws from

the bottom of the front panel and detach from chassis

Step 3

E: Slide out the plastic

retainer

Step 4

F: Pull the circuit

board away from the front panel

Step 5

G: Gently line up and

place circuit board with the rack-mount panel

Step 6

H: Slide the plastic

retainer back into place

Step 7

I: Plug in the ribbon

connector

J: Replace the screws

to the bottom of the rack-mount panel

Step 8

K: Replace the cover

onto the unit

L: Replace the screws

to the RVL-6 cover