Netgear FS108PEU Quick Start Guide

3. Install the switch and connect the other devices.

2. Prepare to install the switch.

1. Unpack the box and verify the contents.
Estimated Time: 5-10 minutes

Installation Overview

install separate electrical wiring and power outlets in new or hard to reach places.
adopted in the market, saving up to 50% of overall installation costs by eliminating the need to
that are powered by PoE are generically called Powered Devices (PD). PoE is already widely
telephones, wireless LAN access points and IP cameras, for a distance up to 100 Meters. Products
Using category 5/5e cable or better, PoE will provide power to PoE compatible device, such as IP
The FS108P complies with the 802.3af standard.
standard defines how products should provide and receive power over the data infrastructure.
eliminating the need to have AC power adapters available at all locations. The IEEE 802.3af
Power over Ethernet (PoE) integrates power and data onto one single cabling infrastructure,

Power over Ethernet (PoE)

Model FS108P ProSafe 8 Port Fast Ethernet Switch with 4 Port PoE

ministère des Communications du Canada.
radioélectriques visant les appareils numériques de classe B prescrites dans le Règlement sur le brouillage radioélectrique du
Cet appareil numérique (NETGEAR Model FS108P ProSafe 8 Port Switch with 4 Port PoE) respecte les limites de bruits

Règlement sur le brouillage radioélectrique du ministère des Communications

Department of Communications.
limits for radio-noise emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian

This digital apparatus (NETGEAR Model FS108P ProSafe 8 Port Switch with 4 Port PoE does not exceed the Class B

Canadian Department of Communications Radio Interference Regulations

Conformity is declared by the application of EN 55 022 Class B (CISPR 22).
generation of radio interference in accordance with the application of Council Directive 89/336/EEC, Article 4a.

This is to certify that the NETGEAR Model FS108P ProSafe 8 Port Switch with 4 Port PoE is shielded against the

EN 55 022 Declaration of Conformance

• Consult the dealer or an experienced radio/TV technician for help.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Increase the separation between the equipment and receiver.

• Reorient or relocate the receiving antenna.
encouraged to try to correct the interference by one or more of the following measures:
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

• This device must accept any interference received, including interference that may cause undesired operation.

• This device may not cause harmful interference.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

Notice

08 P

FS1

MODEL

Fast Ethernet Switch

numbers).
([e-mail]) and by phone (see the provided support information card for phone
a day and 7days a week on the Web (www.NETGEAR.com ), by e-mail
each appliance. If you have a problem with your switch, NETGEAR offers free support 24 hours
will automatically detect the device's power requirements, and will supply the required power to
drive WLAN access points, IP phones, IP cameras and other POE-capable devices. The switch
devices. The switch will provide up to 15.4 W of power on each POE port and can be used to
standards-based PoE, and will automatically detect the presence of IEEE 802.3af-compliant
FS108P provides 8 ports of standard networking. Ports 1 through 4 of this Switch can provide
both 100Mbps Fast Ethernet and 10Mbps Ethernet capabilities in a sturdy, compact package, the
This switch provides Power over Ethernet (PoE) capabilities in a small form factor. Integrating
Congratulations on your purchase of the NETGEAR® ProSafe 8 Port Switch with 4 Port PoE.

Introduction

Federal Communications Commission (FCC) Compliance Notice: Radio Frequency

をして下さい。
機に近接して使用されると、受信障害を引き起こすことがあります。取扱説明書に従って正しい取り扱い
す。この装置は、家庭環境で使用することを目的としていますが、この装置がラジオやテレビジョン受信
この装置は、情報処理装置等電波障害自主規制協議会（VCCI）の基準に基づくクラスＢ情報技術装置で

Voluntary Control Council for Interference (VCCI) Statement

compliance with the regulations.

been notified of the placing of this equipment on the market and has been granted the right to test the series for
restrictions. Please refer to the notes in the operating instructions. Federal Office for Telecommunications Approvals has
equipment (for example, test transmitters) in accordance with the regulations may, however, be subject to certain
accordance with the conditions set out in the BMPT-AmtsblVfg 243/1991 and Vfg 46/1992. The operation of some

It is hereby certified that the NETGEAR Model FS108P ProSafe 8 Port Switch with 4 Port PoE has been suppressed in

Certificate of the Manufacturer/Importer

occur due to the use or application of the product(s) or circuit layout(s) described here in.
changes to the product described in this document without notice. NETGEAR does not assume any liability that may
In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to make

Statement of Conditions

Technical Support

PLEASE REFER TO THE SUPPORT INFORMATION CARD THAT SHIPPED WITH
YOUR PRODUCT.

By registering your product at www.NETGEAR.com/register, we can provide you with faster
expert technical support and timely notices of product and software upgrades.

NETGEAR, INC.

Support Information

Phone: 1-888-NETGEAR (For US & Canada only) - 24 x7 phone support

See Support Information card for other countries.

E-mail: [e-mail] (24 x 7 online support)

www.NETGEAR.com

ProSafe 8 Port Switch with 4 Port PoE

10/100 Mbps FS108P

© 2004 NETGEAR, Inc. NETGEAR, the Netgear logo, The Gear Guy, ProSafe, Auto Uplink
and Everybody's Connecting are trademarks or registered trademarks of Netgear, Inc. in the
United States and/or other countries. Microsoft and Windows are registered trademarks of
Microsoft Corporation in the United States and/or other countries. Other brand and product
names are trademarks or registered trademarks of their respective holders. Information is subject
to change without notice. All rights reserved

October 2004

2 0 1 - 1 0 3 8 9 - 0 1



Installation Guide