Netgear AXM752 Quick Start Manual

)NSTALLATION'UIDE

XFP GBIC Module AXM752

The 10 Gigabit small form-factor pluggable (XFP) module provides one
full-duplex 10G bps Ethernet link operation on NETGEAR managed
switches.

Due to the automatic detection capability of the switch, installation of
AXM752 only requires that you plug the module into the module slot.

The module can be inserted or removed while the switch is operational.

Installing a AXM752 Module

Insert the module firmly into the slot that supports the XFP interface.

Make sure the optical cable you use is single mode LC to LC duplex
cable.

Removing a AXM752 Module

Release the module latch by pulling down the handle bar across the
module, and pull the module out of the module slot.

Specifications

Standard IEEE 802.3ae

10GBase LR

Dimensions (HxWxD) 0.33” x 0.72” x 3.07”

(85.mm x 18.35mm x 78.0 mm)

Weight 0.1 lb (47g)

Operating Temperature 32- 158 F (0-70c)

Storage Temperature 32-185 F (0-85c)

Operative relative humidity 6.23 mi (10km)

Operating Distance LC SM for 9um cable

Connectors LC SM for 9um cable

Power Consumption 2.1w (max: 2.5w)

MTBF 459656 hr (52 years)

Safety Certification UL 1950

CSA 22.2 No. 950

Statement of Conditions

Certificate of Manufacture/Importer

Laser Safety Warning

In the interest of improving internal design, operational function, and/or
reliability, NETGEAR reserves the right to change the product
described in this document without notice. NETGEAR does not assume
any liability that may accrue due to the use or application of the
product(s) or circuit layout(s) described herein.

March 2006

It is hereby certified the NETGEAR model AXM752 has being suppressed
in accordance with the condition set out in MBPT-Amtsb|Vfg 243/1991 and
vfg 46/1992. The operation of some equipment (for example, test
transmitters) in accordance with regulation may, however, be subject to
certain restrictions. Please refer to the note in the operating instructions.
Federal Office for Telecommunications Approvals has being notified of the
placing of this equipment on the market and has being granted the right to
test the series for compliance with regulation.

Note: This device has being tested and found to comply with limits for a
Class B digital device, pursuant to part 15 of FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
commercial installation.

This is Class 1 laser product

Warning - Because invisible laser radiation may be emitted from aperture of
the port when no fiber cable is connected, avoid exposure to laser radiation
and do not stare into open aperture.

This symbol was placed in accordance with the European Union Directive
2002/96 on the Waste Electrical and Electronic Equipment (the WEEE
Directive). If disposed of within the European Union, this product should
be treated and recycled in accordance with the laws of your jurisdiction
implementing the WEEE Directive.

© 2006 by NETGEAR, Inc. All rights reserved. NETGEAR is a registered trademark of NET­GEAR, Inc. in the United States and/or other countries. Other brand and product names are
trademarks or registered trademarks of their respective holders. Information is subject to change
without notice.